Solace Pro

Charging

The device indicates charging status with an LED light. A full charge is indicated when the red light turns off. The device shows 0% charge and can operate for approximately 135 minutes on a full charge.

Operation and Controls

Power On/Off: Hold the power button for 3 seconds.

Thrusting: One tap to start/stop thrusting.

Pattern Mode: One tap to start pattern mode and change patterns (4 patterns available). Press any other button to exit pattern mode.

Stroke Speed: (8 levels)

• Button A: One tap to increase stroke speed. Hold to gradually increase levels.
• Button B: One tap to decrease stroke speed. Hold to gradually decrease levels.

Thrust Depth: (4 levels)

• Button C: One tap to increase thrust depth. Hold to gradually increase levels.
• Button D: One tap to decrease thrust depth. Hold to gradually decrease levels.

Desk Mount Installation

Components: Desk Mount, Main body, Stroker, Sleeve, Charger, Bag, Screws (X, Y, Z).

Step 1: Install the Desk Mount

Attach the desk mount by turning Screw (X) clockwise. The maximum desk thickness supported is 55mm.

Step 2: Attach the Main Body

Insert the slider of the main body into the correct slots on the desk mount.

Step 3: Adjust Height

Slide the main body up or down to adjust to the required height. Secure the position by turning Screw (Y) clockwise.

Step 4: Adjust Angle

Adjust the main body to the desired angle and secure it by turning Screw (Z) clockwise.

Cleaning

Remove the stroker and take out the sleeve. Only the sleeve and stroker can be washed with water. DO NOT get the main body wet.