Home | Vecima Networks, Inc.
User Guide for VECIMA models including: ECM Odometer Source, ECM Odometer, ECM Source, ECM
Dec 26, 2022 — Vehicles with beacons that connect to the J1939* port will obtain the odometer reading directly from the vehicle Engine. Control Module (ECM).2 pages
File Info : application/pdf, 2 Pages, 124.04KB
DocumentDocumentECM ODOMETER SOURCE USER GUIDE Changing the J1939 ECM Odometer Source Changing the J1939 ECM Odometer Source Vehicles with beacons that connect to the J1939* port will obtain the odometer reading directly from the vehicle Engine Control Module (ECM). There are multiple sources for the ECM odometer, which may not precisely match the dashboard odometer. This feature allows users to change the source of the ECM odometer to one that matches the dashboard. The feature is available in both the Commercial Portal as well as the Beacon Test Page. * The J1939 protocol is supported on the green or black 9-pin diagnostics port, or the RP1226 port. Commercial Portal To change the ECM Odometer Source in the Commercial Portal, open the Vehicle tab, find the vehicle and click on the left triangle to open the vehicle information sub-tabs. 1. Click on the J1939 sub-tab to reveal the menu shown in the image. The current ECM odometer and source are displayed at the top of the tab. 2. If the displayed odometer does not match the current dashboard odometer, select an alternate source from the drop down menu. 3. Click the "change" button. 4. To refresh the data displayed in the portal, turn the vehicle ignition off and on again, and click the "refresh" button. 5. This process may be repeated until the portal odometer value matches the vehicle dash odometer. rev 2022.12.21 Page 1 of 2 www.vecima.com © 2022 Vecima Networks Inc. All rights reserved. ECM ODOMETER SOURCE USER GUIDE Changing the J1939 ECM Odometer Source Dealer Portal For users with access, the menu to change the ECM Odometer Source is also located on the Beacon Test Page within the Dealer Portal, or on a mobile device. The Dealer Portal is found at the following address: <dealer>.dp.contigo.com and the mobile test page may be found here: <dealer>.dp.contigo.com/beaconTest/ 1. With the ignition on, tap or click the "start" button. The current ECM odometer and source will be displayed, as well as the drop down menu of alternate ECM sources. 2. If the ECM odometer does not match the dashboard odometer, select a new source and tap "change". 3. Turn the ignition off and on again to display the new result. 4. If the result still does not match the dashboard, steps 2 and 3 may be repeated. 5. Tap "done" to close the menu. If the available odometer source options do not provide an accurate odometer reading, please contact Vecima Support at support.telematics@vecima.com rev 2022.12.21 Page 2 of 2 www.vecima.com © 2022 Vecima Networks Inc. All rights reserved.