LED Lighting for Everything | Super Bright LEDs
User Manual for SYPER BRIGHT LEDS models including: 70W LED, Flood Light, Yoke Mount, LED Light
70W LED Flood Light with Yoke Mount - 9,100 Lumens - 250W Metal Halide Equivalent - 5000K | Super Bright LEDs
File Info : application/pdf, 2 Pages, 2.00MB
DocumentDocumentImportant: Read all instructions prior to installation. LED Flood Light Safety and Notes · Product should be installed and serviced in accordance with applicable national, state, and local building and electrical codes. · To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures. · Avoid looking directly into lamp when illuminated. · Ensure all mounts are securely attached and will support the weight of the fixture. Failure to properly support fixture may result in damage or injury, for which the manufacturer does not assume responsibility. User Manual AFLD Series AFLD-50K30-110-U Specifications Specifications Operating Temperature Environmental Rating AFLD-50K15-110-x Check product label for specific electrical specifications related to installation. Improper installation will void warranty. AFLD-50K30-110-x AFLD-50K50-110-x -40°113° F (-40°45° C) IP65 AFLD-50K70-110-x AFLD-50K90-110-x Wiring Diagram Line Neutral Ground 120277 VAC Input L L N N GND GND Black White Green Dim (+) Dim (-) 110 V Dimming + + - - Purple Gray/Pink Installation Instructions (U-bracket/Yoke Mount) 1. Drill holes for mounting and wiring. 2. Loosen light head adjustment screws with hex key. 3. Securely attach light to wall and connect wiring. 4. Rotate light head to desired angle and tighten adjustment screws. Wall Drill hex-key Rev Date: V1 02/14/2022 4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com Important: Read all instructions prior to installation. LED Flood Light Installation Instructions (Knuckle Mount) water-proof gasket cover of junction-box screw lamp wires knuckle mount User Manual AFLD Series 1. Open junction box and run wiring into box. 2. Securely mount light to junction box. Use sealant to create weatherproof seal. 3. Connect wiring. 4. Replace junction box cover. 5. Rotate light head to desired angle and tighten adjustment screws. L Black N White Green DC(+) Purple(DIM+) DC(-) Pink(DIM-) 1-10VDimming Installation Instructions (Slip-fitter) hex-key Only available on 70 W and 90 W lights. 1. Loosen light head adjustment screw with hex key. 2. Connect wiring. 3. Securely attach light to pole/post. The maximum pole/ post diameter is 2.375 in. 4. Rotate light head to desired angle and tighten adjustment screw. L N DC (+) DC (-) 1-10V Dimming Black White Green Purple(DIM+) Pink(DIM-) Rev Date: V1 02/14/2022 4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com