XCHENG TECH D1 Quick Guide

Technical Specifications

ATTENTION

Warning

• Read all instructions and safety information before use to avoid injury.
• The limit operating ambient temperature of the device declared by the manufacturer is -10~45°C.

Battery safety

• Charge battery only at ambient temperatures ranging from 0~40°C.
• Dispose of used batteries according to manufacturer's instructions.
• Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type of battery recommended by the manufacturer.

Statement

• The equipment damage caused by natural disasters, falling, self disassembly and non-compliance with the operation specifications is not covered by the free warranty.
• Some details of this document may be inconsistent with the real object due to the update iteration of the product. Please take the real object as the standard, and XCHENG TECH reserves the right to interpret this document.

Product Diagram

The device features a 10.1" Main Display for commercial settlement and a 4" Second Display for business information or password entry. It includes an NFC Card Reader for contactless data acquisition, an IC Card Reader for secure chip card insertion, and a Magnetic Stripe Card Reader for encrypted card information. A Scan Window is used for QR code capturing and identification. The device also has a 3-inch thermal printer with an auto-cut feature and a printer button to open the cover and feed new paper. A reset button is located behind the battery cover for device restarts.

Card selection instructions show the placement for mini-SAM, micro-SD, and nano-SIM cards.

Printer instructions indicate support for 3-inch thermal paper rolls (80*60mm) and proper paper feeding direction. If the printed paper is blank, users should check the paper roll installation.

FAQ

How to connect Wifi on D1?

1. Go Settings-Network & internet-WiFi.
2. Click Wi-Fi, scroll down to choose your Wi-Fi.
3. Enter the password to connect.

How to connect Bluetooth on D1?

1. Go Settings-Connected devices.
2. Click Pair new device.
3. Scroll down the “Available devices”, click your device.
4. Click "pair" on both D1 and your device.
5. Back to "Connected devices", click your device in “Previously connected devices" to connect.

FCC Information

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC warning statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment. The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

RF exposure statement

This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter and must be installed to provide a separation distance of at least 20cm from all persons.

Package List