Assembly Instructions
Please keep this manual as it contains important information.
Important Safeguards
Always enter the enclosure only through the door of the net zipper. High winds increase the chance of a trampoline with enclosure being blown over. Always secure your trampoline by using an anchor kit. Adequate overhead clearance is essential. A minimum of 24 ft from the ground level is recommended. Provide clearance for wires, trees, and other obstacles. It is recommended for at least 2 able-bodied adults to set up the trampoline net.
Care and Maintenance
While every attempt is made to ensure the highest degree of quality and protection in all equipment, we cannot guarantee complete exemption of injury. The user assumes all responsibility of injury due to use of this equipment. All merchandise is sold on this condition, and all equipment is used at the consumer's risk.
Liability
Always inspect your trampoline and enclosure before each use and regularly replace any worn, defective, or damaged parts.
This object is subject to wear and tear. No warranties whether expressed or implied are provided. Injury will likely occur with the use of a trampoline or any associated product. Use with supervision. Use at your own risk. Only use in a well-lit, well-secured area.
Parts Included
- Trampoline Pad x1
- Bungee Ropes x12
Description of Trampoline Pad: A circular pad, typically blue, with attachment loops along its edge.
Description of Bungee Ropes: Elastic cords, usually black, with a blue ball end for attachment.
Attaching the Pad
Step 1
Remove your old pad by detaching the ties attached to the trampoline frame at the bottom of the pad. Lay your new pad on top of your exposed springs.
Step 2
Locate the black loops on the bottom side of your pad. At each loop, take a bungee rope and thread it through the loop. Next, wrap the bungee around the outside metal frame, pulling one end of the bungee and wrapping it around the ball end.
Illustration Description: A diagram shows a trampoline frame. Bungee ropes are depicted being threaded through the black loops on the underside of the trampoline pad and then wrapped around the outer metal frame of the trampoline. The ball end of the bungee is shown secured.
Step 3
Finally, pull the pad down to cover your frame and bungees. You are all set!
