Instruction Manual for Current models including: WSP-L360-WH Occupancy Sensors Lens, WSP-L360-WH, Occupancy Sensors Lens, Sensors Lens

Manual de Instalación

Lente Para Sensor De Movimiento - Para Montajes Bajos

Occupancy Sensors Lens INSTALLATION INSTRUCTIONS

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized
• Document:
  • References

File Info : application/pdf, 1 Pages, 305.59KB

Occupancy Sensors Lens INSTALLATION INSTRUCTIONS
LENS SPECIFICATIONS · Coverage: lens: 3:1 coverage up to 8-16 ft.. Example: 8 ft. mounting x 3 = 24 ft. radius. · Low Temp/ Water Tight/ Indoor-Outdoor (LWO) lenses must be used with LWO sensors in order to insure proper operation.
INSTRUCTIONS NOTE: prior to installing the lens onto the sensor body, apply a generous amount of the supplied O-ring lubricant to the entire length of the lens O-ring. Failure to do so may allow water to enter the housing and will void the warranty. 1. To attach lens: Place lens assembly flush onto sensor module and rotate clockwise approximately five degrees to lock into place (see Figure 1.) Lens may be
installed on sensor module rotated ninety degrees (See Figures 3 and 4.) 2. To remove lens: Rotate lens assembly counter clockwise approximately five degrees and lift off.
Figure 1 ­ Lens installation Figure 2 ­ 360 lens Figure 3 ­ Aisle lens installed 90o Figure 4 ­ Aisle lens installed 180o

Fig 5. Sensor Lens Coverage and Detection Patterns When Mounted at 8ft with Low Mount Lens

Fig 6. Sensor Lens Coverage and Detection Patterns When Mounted at 30ft and 45ft with Standard Lens

currentlighting.com
© 2022 HLI Solutions, Inc. All rights reserved. Information and specifications subject to change without notice. All values are design or typical values when measured under laboratory conditions.

72-00536, Rev. B
Page 1 of 1 Rev 06/10/22 2104B_WASP-Lens_Install



References