KODAK Wireless LED Speaker

Important Safety Instructions

• Read and follow all instructions.
• Keep instructions in a safe place.
• Do not use near water.
• Cleaning: Use only a dry damp cloth. Do not use liquid or aerosol cleaners.
• Keep away from heat sources like radiators, heat registers, stoves, or amplifiers that produce heat.
• Use only manufacturer-specified attachments/accessories.
• Refer servicing to qualified personnel for damage, abnormal operation, or drops.

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) it may not cause harmful interference, and (2) it must accept any received interference, including interference that may cause undesired operation.

Note 1: FCC Class B Compliance

This equipment has been tested and found to comply with Class B digital device limits per FCC Rules. These limits provide reasonable protection against harmful interference in residential installations. The equipment generates, uses, and can radiate radio frequency energy. If not installed and used per instructions, it may cause harmful interference to radio communications. Interference is not guaranteed to not occur in a specific installation. If interference occurs (determined by turning off/on), the user is encouraged to correct it by:

• Reorienting or relocating the receiving antenna.
• Increasing separation between equipment and receiver.
• Connecting the equipment to a circuit different from the receiver's.
• Consulting the dealer or an experienced radio/TV technician.

Note 2: Modifications

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits for an uncontrolled environment. The transmitter must not be co-located or operating with any other antenna or transmitter.

IC Warning

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to two conditions: (1) it may not cause interference, and (2) it must accept any interference, including interference that may cause undesired operation.

Under Industry Canada regulations, this radio transmitter may only operate using an antenna type and maximum (or lesser) gain approved by Industry Canada. To reduce potential radio interference, the antenna type and gain should be chosen so that the equivalent isotropically radiated power (e.i.r.p.) is not more than necessary for successful communication.

ISEDC Radiation Exposure Statement

This equipment complies with ISEDC RF radiation exposure limits for an uncontrolled environment. This transmitter must not be co-located or operating with any other antenna or transmitter.

IC exposition aux radiations

This equipment complies with ISEDC radiation exposure limits defined for an uncontrolled environment. This transmitter must not be co-located or operate in conjunction with any other antenna or transmitter.

This device complies with Canadian ICES-003 and RSS-247.

Thank you for your purchase.

Location of Controls

The speaker has the following controls and ports:

• 1. ON/OFF Switch: Slide to turn the speaker on or off.
• 2. Micro USB Charging Port: Connect the charging cable here.
• 3. Aux-in Port: For connecting audio sources via a 3.5mm cable.
• 4. Charge Indicator Light: Shows charging status.
• 5. USB Input: For playing music from a USB drive.
• 6. MicroSD Input: For playing music from a MicroSD card.
• 7. Next Button / Volume Increase Button: Press to skip to the next track, or press and hold to increase volume.
• 8. Play / Pause Button: Press to play or pause music.
• 9. Previous Button / Volume decrease Button: Press to skip to the previous track, or press and hold to decrease volume.
• 10. Mode Button: Cycles through different input modes (Bluetooth, FM, Aux-in, USB, MicroSD).

Charging the Speaker

Connect the Micro USB tip of the charging cable to the Micro USB Charging Port on the speaker. Connect the other end (USB tip) to a USB port on your computer or a USB wall charger (not included). The LED Indicator Light will be red while charging and turn off when fully charged. A full charge takes approximately 3-4 hours.

Product and Battery Disposal

This product contains a built-in lithium battery and should not be disposed of with normal household waste. The battery is not user-removable. For disposal and recycling, contact local waste management authorities. Recycling electronic waste helps protect the environment.

Warning: To reduce the risk of fire and burns, do not disassemble, crush, puncture, short external contacts, or dispose of in fire or water.

Power On/Off

To turn the speaker on or off, slide the toggle switch to the ON or OFF position.

Bluetooth Mode

Pairing a Bluetooth Enabled Device

Note: Refer to your Bluetooth device's manual for pairing instructions.

1. Keep the speaker and your Bluetooth device within 1 meter during pairing.
2. Turn on the speaker and press the Mode Button to select Bluetooth mode.
3. Turn on the Bluetooth function on your device and search for Bluetooth devices. Select "BTSPK110" from the list.

Notes on Pairing:

• If pairing fails, turn the speaker off and repeat the steps.
• Once paired, devices remember each other. Re-pairing is not needed unless pairing information is deleted.
• To pair with a different device, disconnect the current device first.

Controls in Bluetooth Mode:

• To adjust volume: Press and hold the Volume Increase (+) or Volume Decrease (-) Button (7 or 9).
• To skip tracks: Press the Next (7) or Previous (9) Button.
• To pause/resume playback: Press the Play/Pause Button (8).

FM Mode

Press the Mode Button to select FM Mode. Press and hold the Play/Pause Button (8) to start the auto search function. Saved stations can be navigated using the Previous (9) or Next (7) Buttons.

Tips for Best Reception: If FM reception is weak, try changing the unit's position or placing it near a window.

Aux-in (Audio Input) Mode

Connect one end of a 3.5mm aux-in cable (not included) to your audio source (smartphone, tablet, MP3 player) and the other end to the Aux-in Port (3). Press the Mode Button to select Aux-in Mode.

USB Mode

Play MP3 formatted files from a USB thumb drive. Insert the drive into the USB Input (5). Press the Mode Button to select USB Mode.

Micro SD Mode

Play MP3 formatted files from a MicroSD memory card. Insert the card into the MicroSD Input (6). Press the Mode Button to select MicroSD Mode.

Note on MicroSD Card: To insert, use a fingernail to push until it clicks. To remove, push it in again until it clicks out. The card can remain in the speaker without affecting mode cycling.

Need Help?

If you encounter difficulties, please call or email Edco Electronics Support. Representatives are available to assist you.

Toll Free: 1-800-593-6669 (Monday to Friday: 9am – 5pm EST)

Email: support@borne-lifestyle.com

Thank you for your purchase. We hope you enjoy your product.

Limited Warranty

The Kodak trademark is used under license from Kodak.

Warning: Some products may contain small components that can be swallowed. Keep out of reach of children.

Before returning your product for service, read the manual and visit www.borne-lifestyle.com for updates and support. Contact Edco Electronics Support if you continue to have trouble.

Edco Electronics warrants the original purchaser ("Customer") that the Product will be free from defects in material or workmanship under normal, noncommercial use for a period of 1 year from the original purchase date.

Coverage Periods: Parts are covered for 1 year; Labor is covered for 90 days.

If a defective product is returned within the warranty period, Edco Electronics will, at its option, repair or replace the product with a new or refurbished unit. This service is free of charge for parts and/or labor within the specified coverage periods, excluding shipping charges which are the Customer's responsibility.

Warranty Exclusions: This warranty does not cover defects resulting from:

• Neglect, misuse, accidents, improper application, violation of operating instructions, customer-induced damage, or alteration/removal of serial numbers.
• Modification or repair by unauthorized parties.
• Damage from power surges, incorrect voltage, misconnections, or device malfunctions.
• Cosmetic damage from normal wear and tear.
• Shipping damage during transit.
• Damage from heat sources, sunlight, electromagnetic conditions, or climatic conditions.
• Acts of God.

The product is sold for personal, non-commercial use only. It is not warranted for commercial or rental use. It should not be used in applications where data stored on the product is critical for medical or lifesaving purposes, as Edco Electronics disclaims any warranty for such uses.

Products purchased as "floor" or "display" models are sold "AS IS" without any warranties.

Limitation of Liability: EXCEPT FOR EXPRESS WARRANTIES, THE PRODUCT IS PROVIDED "AS IS". EDCO ELECTRONICS DISCLAIMS ALL OTHER WARRANTIES, INCLUDING IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT. EDCO ELECTRONICS IS NOT LIABLE FOR INDIRECT, SPECIAL, INCIDENTAL, CONSEQUENTIAL, EXEMPLARY, OR PUNITIVE DAMAGES, INCLUDING LOST PROFITS OR DATA LOSS, REGARDLESS OF THE THEORY OF LIABILITY. EDCO ELECTRONICS' AGGREGATE LIABILITY FOR DIRECT DAMAGES IS LIMITED TO THE CUMULATIVE PRODUCT COSTS PAID BY THE CUSTOMER.

Obtaining Warranty Service:

Customer must call Edco Electronics Support before returning a product.

Required items for return:

• Dated sales receipt showing place of purchase, model number, and amount paid.
• Detailed description of the problem.
• Customer's full name, phone number, and return address.
• Money order for applicable shipping costs (payable to Edco Electronics Inc.) for return shipping to US and Canadian destinations.

Edco Electronics does not ship to P.O. Boxes. Actual freight charges apply for international addresses. Failure to include required items may delay warranty processing.

Return product freight-prepaid in original or protective packaging. Allow 4 to 6 weeks for claim processing.

Edco Electronics Inc.
8484 Esplanade,
Montreal, Quebec H2P 2R7
Canada
Toll Free: 1-800-593-6669 (Monday to Friday: 9am to 5pm EST)
Email: support@borne-lifestyle.com