PowerBox iGyro 3xtra Quickstart Manual

Setting the Installed Position

Follow these steps to set the initial position for the iGyro 3xtra:

1. Step 1: Initialisation

   Press and hold the white button on the iGyro 3xtra. While holding the button, switch the model on. Release the button as soon as the red LEDs cycle.

2. Step 2: Elevator Neutralisation

   Lift the model quickly and hold it until the elevator returns to its neutral position.

3. Step 3: Rudder Neutralisation

   Quickly move the model's tail to the right and hold it until the rudder returns to its neutral position.

LED Indicators:

• ? RUDDER
• ? ELEV-B
• ? ELEV-A
• ? AILE-B
• ? AILE-A

Learning the Centre and End-Points

This section describes how to teach the iGyro 3xtra the center and end-point positions for each control axis using your transmitter.

1. Step 1: General Setup

   Ensure the iGyro 3xtra is connected and powered on. The device will show initial LED states.

2. Step 2: Learning Aileron Stick Right

   Move the transmitter's aileron stick fully to the right . Press the white button on the iGyro 3xtra once [press once].

3. Step 3: Learning Aileron Stick Left

   Move the transmitter's aileron stick fully to the left . Press the white button on the iGyro 3xtra once [press once].

4. Step 4: Learning Elevator Stick Down

   Move the transmitter's elevator stick fully down . Press the white button on the iGyro 3xtra once [press once].

5. Step 5: Learning Elevator Stick Up

   Move the transmitter's elevator stick fully up . Press the white button on the iGyro 3xtra once [press once].

6. Step 6: Learning Rudder Stick Right

   Move the transmitter's rudder stick fully to the right . Press the white button on the iGyro 3xtra once [press once].

7. Step 7: Learning Rudder Stick Left

   Move the transmitter's rudder stick fully to the left . Press the white button on the iGyro 3xtra once [press once].

Note: Green LEDs indicate successful learning for the current input. Red LEDs may indicate an issue or the opposite direction is being learned.

Gain Adjustment for Individual Axes

This section details how to adjust the gain for each control axis independently.

1. Step 1: Select Axis

   Press the white button on the iGyro 3xtra to cycle through the axes (Rudder, ELEV-B, ELEV-A, AILE-B, AILE-A). The selected axis will be indicated by its LED.

   Visual description: A hand is shown pressing the white button on the iGyro 3xtra device.

2. Step 2: Adjust Gain

   Use your transmitter's control stick for the selected axis to adjust the gain. The iGyro 3xtra will indicate the gain level with LEDs and the corresponding percentage change:

   • ? +10%
   • ? +5%
   • ? -5%
   • ? -10%

   Visual description: A transmitter stick is shown moving left and right (or up/down), with corresponding plus and minus symbols indicating direction of adjustment. Arrows show the direction of stick movement and gain change.

   Example: To increase gain, move the stick in the direction indicated by the plus symbol . To decrease gain, move the stick in the direction indicated by the minus symbol .