Setup Guide
Follow these steps to set up your Sonos Roam 2.
Step 1: Power On
Press the power button. When the Sonos Roam 2 is ready to be configured, the status light will turn green, and you will hear a welcome sound.
Step 2: Connect Your Device
To enter Bluetooth pairing mode:
- Press and hold the Bluetooth button until the light turns blue.
- Then, connect to Roam 2 from your device's Bluetooth settings.
Download the Sonos app to complete the configuration, personalize settings, and access exclusive features.
At a Glance
Use Bluetooth anywhere, stream over WiFi at home.
Device Controls
- Power [?]: Press to power on, sleep, or wake. Press and hold to power off.
- Bluetooth [?]: Press and hold to pair. Press to reconnect.
- Microphone [?]: Press for voice control and microphone-related features.
- Next / Previous [▶️▶️ / ▶️▶️▶️]: Double press for the next track, triple press for the previous track.
- Group or Swap [?]: Press and hold to group Sonos products. Continue holding to swap audio between them.
- Volume [- / +]: Use the buttons to adjust volume down or up.
Status Light
- Flashing White: Starting up
- Flashing Green: Ready to set up
- Flashing Blue: Bluetooth pairing
- Solid Blue: Bluetooth connected
Support & Resources
Customer Support: sonos.com/support
User Guide: sonos.com/guides/sonosroam2
Terms of Use, License and Warranty: www.sonos.com/legal/terms-of-use
© 2024 Sonos, Inc. All rights reserved. Sonos", and Sonos Roam 2 are trademarks or registered trademarks of Sonos, Inc. "Reg. U.S. Pat. & TM Off.
Important Product Information
This device complies with FCC and Industry Canada regulations. For detailed information on RF exposure, consult the relevant safety codes and regulations. A minimum separation distance of 20cm (8 inches) is required between the equipment and the user or nearby persons.
Safety Information
- Read and keep these instructions.
- Heed all warnings and follow all instructions.
- Clean only with a dry soft cloth. Household cleaners or solvents can damage the finish.
- Do not block ventilation openings. Install according to manufacturer's instructions.
- Do not install near heat sources like radiators or stoves.
- Protect the power cable from being walked on or pinched.
- Use only manufacturer-specified attachments/accessories.
- Unplug during lightning storms or when unused for long periods.
- Refer all servicing to qualified Sonos personnel.
- The mains plug should be readily available to disconnect the equipment.
- Sonos Roam 2 meets IP67 water resistance levels.