User Guide for CHAMPION models including: 100719 8500W Electric Start Inverter Generator, 100719, 8500W Electric Start Inverter Generator, Electric Start Inverter Generator, Start Inverter Generator, Inverter Generator, Generator

100719-qs-web

Scott Henning

Quick Start Guide for All in English / Español

8500-Watt Inverter with CO Shield - Champion Power Equipment


File Info : application/pdf, 4 Pages, 419.41KB

PDF preview unavailable. Download the PDF instead.

100719-qs-web
quick st rt
QUICK START GUIDE · GUÍA DE INICIO RÁPIDO

100719
8500W Electric Start Inverter Generator Generador Inversor de Encendido Eléctrico 8500W

WARNING:
Read the ENTIRE operator's manual to become familiar with the features of the product before operating.
Failure to operate the product correctly can result in damage to the product, personal property and cause serious injury or even death.

ADVERTENCIA:
Lea el manual del operador COMPLETAMENTE para familiarizarse con las características del producto antes de operarlo.
La falla en operar el producto correctamente puede resultar en daños al producto, propiedad personal y causar lesiones graves o incluso la muerte.

www.championpowerequipment.com © Champion Power Equipment 2022.
All Rights Reserved. / Todos los derechos reservados.
3649-M-OP REV 20220630 EN ES

Set Up / Montaje

1.

Open shipping carton. Assembly > Unboxing Abra el cartón de envío. Montaje > Desempacando

2.

Remove brackets. Assembly > Remove the orange bolts
Remueva las ménsulas. Montaje > Remueva las Pernos anaranjados.

1

2

3.

Attach wheel kit. Assembly > Install the Wheel Kit Fije el juego de ruedas.

A

Montaje > Instale el Juego de Ruedas

A

B

B

×2

4.

Connect the battery. Assembly > Connect the Battery.
Push two halves of battery connector together tightly.

Conecte la batería.

Montaje > Conecte la Batería
Empuje las dos mitades del conector de la batería firmemente.

A

5.

Add oil. Assembly > Add Engine Oil.
Recommended: 10W-30, up to 37.2 fl. oz. (1100 ml) DO NOT overfill.
Agregue aceite. Montaje > Agregue Aceite al Motor.
Recomendado: 10W-30, hasta 37.2 fl. oz. (1100 ml) NO sobrellene.
MAKE SURE SHIPPING BRACKETS ARE REMOVED BEFORE ADDING OIL.
ASEGURE QUE LAS MÉNSULAS DE ENVÍO ESTÉN REMOVIDAS ANTES DE AGREGAR ACEITE

Start Up / Arrancar
10W-30

6.

Move the generator outdoors. / Mueva el generador afuera.

Move generator to an open, outdoor area. Point exhaust away from people and buildings. Never run generator inside a home or garage.

Keep all objects at least 5 feet (1.5 m) from generator. Heat from the muffler and exhaust gas can ignite combustible materials.

Mueva el generador a un área abierta al aire libre. Dirija el escape alejado de personas e inmuebles. No opere el generador dentro de un hogar o garaje.

Mantenga todos los objetos por lo menos 5 pies (1.5m) del generador. El calor del silenciador y el gas del escape pueden incendiar objetos combustibles.

7.

Add fuel. Assembly > Add Fuel
DO NOT use E15 or E85.
Agregue combustible. Montaje > Agregue combustible.
NO use E15 o E85.

8.

DO NOT plug in any electrical devices. NO enchufe ningún aparato electrónico.

NEVER START OR STOP THE GENERATOR WITH ELECTRICAL DEVICES CONNECTED OR TURNED ON!
¡NUNCA ENCIENDA UN GENERADOR CON APARATOS ELECTRONICOS ENCHUFADOS O ENCENDIDOS!

Start Up / Arrancar

9a.

Electric Start 1. Turn the EZ Start Dial to the "CHOKE" position.

2. Press and hold ignition switch.

3. Turn the EZ Start Dial to the "RUN" position.

1

2

Encendido Eléctrico

1. Gire el dial EZ Start a la posición "AHOGAR".

2. Oprima y mantenga oprimido el interruptor de arranque.

3. Gire el dial EZ Start a la posición "CORRER".

3

9b.

Manual Start
1. Turn the EZ Start Dial to the "CHOKE" position.
2. Remove the maintenance cover on the right side of the control panel.

3. Pull the recoil to start the engine.

1

2

4. Turn the EZ Start Dial to the "RUN" position.

Encendido Manual

1. Gire el dial EZ Start a la posición "AHOGAR".

2. Retire la tapa de mantenimiento en el lado derecho

del tablero de control.

3

4

3. Jale el arrancador retráctil para encender el motor.

4. Gire el dial EZ Start a la posición "CORRER".

10.

Plug in. Operation > Connecting Electrical Loads. Enchufe. Operación > Conectando Cargas Eléctricas.

Visit our YouTube channel to watch our how-to videos and subscribe to view our latest videos on our Champion Power Equipment products!
Visite nuestro canal de YouTube para ver nuestros videos de guías o suscribase para ver los videos más recientes en nuestros productos Champion Power Equipment.

NEED ASSISTANCE OR HAVE A QUESTION? GIVE US A CALL.
NECESITA AYUDA O TIENE ALGUNA PREGUNTA? DÉNOS UNA LLAMADA.

1·877·338·0999
CHAMPIONPOWEREQUIPMENT.COM



References

Adobe PDF library 16.07