Instruction Manual for EasyIO models including: FW14, OEJFW14, FW-14 V3 WiFi Controller, V3 WiFi Controller
Johnson Controls Inc FW14 Building Automation Systems OEJFW14 OEJFW14 fw14
EasyIO FW-14 V3 - Instruction Manual Installation Guide on typical industrial 35mm DIN rail Pull to Unlock the Clip Push to lock clip Wiring Guide WARNING: Class 2 Devices Wiring Only Do Not Reclassify and Install as Class 1, 3 or Power and Lighting Wiring ATTENTION : Câblage destiné aux équipements de classe 2 seulement. Ne pas les reclasser ni les installer avec un câblage de classe 1 ou de classe 3, ou avec un câblage d'alimentation ou d'éclairage. DO1 ~ DO2 is a voltage free contact. External power source is needed either 24 Vac or 24 Vdc. V1.01 EasyIO FW-14 V3 - Instruction Manual Input Rating (UL Listing) Type Supply Universal Inputs Rating 24Vac(+/-5%), 20VA; 24Vdc(+15%/-15%), 15VA, Class 2 Voltage: 0-10 Vdc Class 2; Resistance: 500-500K Ohms Terminal H (Vcc), G (Ground) UI1 ~ 8 and COM (8 sets) Output Rating (UL Listing) Type Digital Outputs (SPST N.O. dry contact) Universal Output Rating 24 Vac, 0.5 A pilot duty, Class 2; 24 Vac, 2 A General Purpose, Class 2; 24 Vdc, 2 A, Class 2; 24 Vdc, 0.5 A pilot duty, Class 2 Voltage: 0-10V, Class 2 Terminal DO1 ~ 2 (pair) AO1 ~ 4 and COM (4 sets) Communication (UL Listing) Type EIA/RS-485 Ethernet Ports (2) Rating Class 2 Class 2 Terminal D+, D-, S ENET0, ENET1 Wireless Rating Description Standard Band Frequency Range Antenna Transmission Power Details IEEE 802.11 b/g/n 2412 MHz ~ 2462 MHz 2dBi Dipole 16.6 dBm EIRP Remarks Regulatory UL 916 Energy Management Equipment FCC Class B , Part 15 , Subpart C 15.247 CE Compliance The Equipment named above is confirmed to comply with the requirements set out in the European Council Directive on the Approximation of the Laws of the Member States relating to 2014/53/EU (RED) The equipment passed the following test which was performed according to the following European standards: EN 300 328 V2.2.2 EN 301 489-1 V2.2.3 EN 301 489-17 V3.2.4 EN 62311: 2008 V1.01 EasyIO FW-14 V3 - Instruction Manual FCC Statement Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. FCC Caution: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Non-modification Statement: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. V1.01Microsoft Word 适用于 Microsoft 365