User Manual for superbrightleds com models including: LPD6 Series Dimmable LED Panel Light, LPD6 Series, Dimmable LED Panel Light
2’x2’ LED Panel Light - 40W - Even-Glow LED Panel Light Fixture - Dimmable - Drop Ceiling - 4000 Lumens | Super Bright LEDs
2’x4’ LED Panel Light - 50W - Even-Glow LED Panel Light Fixture - Dimmable - Drop Ceiling - 5000 Lumens | Super Bright LEDs
Important: Read all instructions prior to installation. Dimmable LED Panel Light Dimensional Drawings 23.75in 603.25mm 47.75in 1212.85mm 3.50in 88.90mm 9.08in 230.70mm 23.75in 603.25mm 9.08in 230.70mm 3.50in 88.90mm 23.75in 603.25mm Rev Date: V2 03/16/2021 User Manual LPD6 Series 0.39in 9.91mm 3/4 INCH CONDUIT KNOCKOUT 1.35in 34.29mm LPD6-xK24-50-S 3/4 INCH CONDUIT KNOCK OUT 0.39in 9.91mm 0.39in 9.91mm LPD6-xK22-40-S Dimmable LED Panel Light LPD6 Series User Manual LPD6-40K24-50-S Rev Date: V2 03/16/2021 Important: Read all instructions prior to installation. Dimmable LED Panel Light User Manual LPD6 Series Included Parts 1 - LED panel Light Recommended Accessories · 010V Slide Dimmer (F019) · 010V Knob Dimmer (A019) Specifications Model Operating Voltage Rated Power Consumption Current Draw Dimmable Operating Temperature Product Weight IP Rating LPD6-xK22-40-S LPD6-xK24-50-S 100277 VAC 40 W 50 W 333 mA (0.33 A)@120 VAC 417 mA (0.42 A)@120 VAC 010 V -4°113° F(-20°45° C) 6 lb (2.7 kg) 12.35 lb (5.6 kg) IP20 Safety Information · Product should be installed by a certified electrician in accordance with applicable national, state, and local building and electrical codes. · To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures. · Avoid looking directly into the light when illuminated. · Failure to properly support the fixture may result in damage or injury, for which the manufacturer does not assume responsibility. A safety cable is not included, but it is recommended that one be connected to grid clip during installation. Wiring Diagram Neutral (white) Line (black) Ground (green) Dim- (gray) Dim+ (purple) Drop Ceiling Installation 1. Turn supply power to circuit off. If installing as a retrofit, remove existing fixture. 2. Open driver box and remove knockout(s) for wiring. Make electrical connections using wiring diagram. Once complete, resecure driver box cover. FIG 1 Firmly bend Safety Tabs up and out Safety Tab 3. Bend out safety tab to be vertical, then upper portion out 90 degrees. It is recommended that a safety cable (included) be installed to anchor the fixture as well. 4. Lay fixture into T-grid. FIG 2 Fixture Safet Tab T-Grid Driver Box Note: Tabs should secure light in T-grid while still allowing reinstallation of adjacent ceiling tiles. Rev Date: V2 03/16/2021Adobe PDF Library 15.0 Adobe InDesign 16.1 (Windows)