Remington Ultimate Series Rx7 Head Shaver

USE & CARE MANUAL

Please read prior to use.

The Remington Ultimate Series Rx7 Head Shaver is designed for efficient and comfortable head shaving.

IMPORTANT SAFETY INSTRUCTIONS

When using electrical appliances, basic precautions should always be observed:

• READ ALL INSTRUCTIONS BEFORE USING
• DANGER: Electrical parts remain live even when the switch is off. It is advisable to install a residual current device (RCD) with a rated residual operating current not exceeding 30 mA in the bathroom's electrical circuit for additional protection. Consult an installer for advice.
• WARNING: TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR INJURY TO PERSONS:
• Never leave the appliance unattended when plugged into a power outlet, except during charging.
• This appliance should not be used by children or persons with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless supervised or instructed on safe usage and aware of the hazards.
• Children shall not play with the appliance.
• Cleaning and user maintenance should not be performed by children without supervision.
• Do not operate if the cord or plug is damaged, if it's not working correctly, if it has been dropped or damaged, or dropped into water. If the supply cord or plug is damaged, it must be replaced by the manufacturer, service agent, or similarly qualified persons to avoid hazards. It cannot be repaired.
• Keep the cord away from heated surfaces.
• Charge, use, and store the product at temperatures between 0°C and 32°C.
• Do not use outdoors or where aerosol (spray) products are used, or where oxygen is administered.
• Do not use with damaged or broken tracks, foils, or cutters, as injury may occur.
• For use on head hair only. Not intended for shaving facial hair.
• Do not plug or unplug the appliance with wet hands.
• For household use only.
• Do not place or store the appliance or charging cable where it can fall into a sink or bath.
• Do not place in or drop into water or other liquids for extended periods.
• If an appliance falls into water, unplug it immediately. Do not reach into the water.
• Unplug the charging cable from the electrical outlet immediately after fully charging.
• Unplug the USB cable and port from the appliance before cleaning it in water.
• Use this appliance only for its intended use as described in this manual.
• Do not use attachments not recommended by Remington.
• Never drop or insert any object into any opening of this appliance.
• Always store the charging cable in a moisture-free location.
• Do not use on people who are asleep.
• Do not use an extension cord or voltage converter with this appliance.
• Do not wrap the cord around the appliance.
• Remington strongly recommends installing an approved Safety Switch (Residual Current Device) for all bathroom power outlets. Consult an electrical contractor.

SAVE THESE INSTRUCTIONS

HC7500AU ULTIMATE SERIES Rx7 HEAD SHAVER USE & CARE INSTRUCTION MANUAL

Thank you for purchasing your new Remington® Ultimate Series Rx7 head shaver. This manual provides tips on using and caring for your shaver.

KEY PARTS

1. On/off button
2. Head assembly
3. Individual flexing blades
4. Hair pocket
5. Pop-up trimmer
6. Turbo button
7. Charging indicator lights
8. Charging connector

Also Includes:

• Head Guard
• Storage Bag
• Cleaning Brush
• USB cable
• Lubricating Oil

A diagram illustrates the shaver with numbered parts: 1. On/off button, 2. Head assembly (including 3. Individual flexing blades), 4. Hair pocket, 5. Pop-up trimmer, 6. Turbo button, 7. Charging indicator lights, and 8. Charging connector.

HC7500AU SPECIFICATIONS

Power System: The shaver is cordless and can only be used when disconnected from the charging cable. It will not run while charging.

CHARGING

Before use, read the important safety instructions.

1. Ensure the product is switched off.
2. Connect the product to the USB cable and plug the USB end into a powered USB port.
3. Charge for 2 hours for the first use to ensure optimal battery life.
4. A full 2-hour charge provides up to 60 minutes of shaving time.

Caution:

• Ensure the shaver and hands are dry when charging.
• Always charge the shaver in a cool, dry place.

CHARGING INDICATOR LIGHTS

During charging:

(● = on, ○ = flashing)

Once fully charged, all 4 lights will stay on for 5 minutes and then turn off.

Charge remaining: After use, when the shaver is switched off, the charging indicator lights display the remaining charge for 5 seconds.

DURING USE

The indicator lights illuminate forwards and backwards in a cycling pattern during use.

• The head shaver cannot be used while charging.
• A full 2-hour charge provides up to 60 minutes of shaving time.
• To preserve battery life, avoid charging after every use. It is best practice to use the shaver until only one light is flashing and then recharge.

Note: Some countries may require a plug adaptor, which is not included.

SHAVING YOUR HEAD

1. Hold the head shaver body in your palm. Press the On/Off switch to turn it on.
2. Press the five cutting heads against your scalp. Do not press hard; pressing harder does not cut closer and may increase irritation. The cutting heads flex to follow the contours of your head.
3. Move the shaver slowly around your head using linear strokes or a rotating motion, whichever you find most effective.
4. Use a hand-held mirror to check the back of your head for a complete shave. You can also use your other hand to feel for consistent cutting.
5. The head shaver is not recommended for facial hair.
6. Turn the shaver off when finished.

TURBO FEATURE

Use the Turbo feature for thick hair. Press the turbo button to activate Turbo mode; the charging indicator light pattern will speed up. Press the turbo button again to deactivate.

SHAVING TIPS

• Do not attempt to shave head hair longer than 4 days growth or 2.0 mm. The Ultimate Series Rx7 is intended for maintaining a shaved look and can be used daily or every two to three days.
• The shaver cannot cut long hair down to a shaved length. If your hair is longer than 2.0 mm, trim it with a hair clipper first.
• The Ultimate Series Rx7 head shaver can be used dry or with shaving cream or gel in the shower.

TRIMMING

Pop-up Trimmer:

The pop-up trimmer is located at the top of the shaver body and can be used for trimming beard edges, sideburns, or ears.

1. Turn the shaver on to activate the trimmer. Slide the release button down for the trimmer to pop up.
2. Use cutting strokes in the direction opposite to how the trimmer folds away.
3. Fold the trimmer into its stored position when finished.

Note: Lubricate the trimmer teeth with oil every 6 months.

CLEANING & MAINTENANCE

• To ensure long-lasting performance, clean the product after each use.
• The Ultimate Series Rx7 head shaver collects hair clippings, minimizing mess.
• Ensure the shaver is switched off and disconnected from the charging cable before cleaning.
• The shaver is washable and can be cleaned by rinsing under warm water.
• When using shaving creams or gels, clean the shaver after each use to prevent clogging.
• Do not use strong detergents or chemicals on the external surfaces.
• Wipe the shaver surface with a dry towel to dry. Do not use a hair dryer or heater.
• The shaver head and neck assembly detaches from the shaver body by pulling upwards. Align the neck with the attachment cavity and push to reattach.
• If the unit pulsates, apply a small amount of light lubricating oil to each cutter head while the unit is off.
• Apply a small drop of oil to a fingertip and touch it to each cutter head, gently wiping the oil onto the cutter. Wipe off excess oil. Re-oil as needed.
• Suitable oils include hair clipper oil, sewing machine oil, or olive oil.

Note: Clean the cutter heads under running water after each use.

SAFETY MODE

The head shaver will turn off and enter safety mode if battery demand is too high, possibly due to inadequate cleaning or excessive hair clippings in the hair pocket.

• If this occurs, open and clean the shaver. The left and right charging indicator lights will flash for ten seconds. After an additional 5 seconds, the shaver will reset and operate normally.

ACCESSORY ORDER FORM

For help or to place an order by phone:

• Australia: 1800 623 118 (toll free)
• New Zealand: 0800 736 776 (toll free)

MONEY BACK OFFER - AUSTRALIA / NEW ZEALAND ONLY

If you are not fully satisfied with your Remington® shaver within 60 days, return the shaver with this completed coupon and a copy of your purchase receipt to Remington®. A cheque for the full purchase price will be sent within 6-8 weeks.

Please provide the following information:

• Name:
• Address:
• City:
• State:
• Postcode:
• DOB:
• Contact No: Area Code: Ph:
• Product Model number:
• Is this the first Remington shaver you have owned/purchased? Yes ☐ No ☐
• Reason for return: Skin Irritation ☐ Shave is not close enough ☐ Product didn't meet expectation ☐ Other:

CLEANING & LUBRICATION INSTRUCTIONS

• After each use, hold the shaver over a bin and remove the top of the shaving head.
• Pull the cutting head unit off the head assembly (see Figure A).
• Empty clippings from the hair pocket into the bin.
• Rinse the head under a running tap (see Figure B).
• Use a cleaning brush to remove shaving debris.
• Shake off excess water and allow to dry before reassembly.
• To maintain optimum performance, lubricate the blades weekly or if the shaver begins to 'pulse'.
• Apply a very small drop of light oil (hair clipper oil or sewing machine oil) onto the inside of each separate cutter head.
• Silicone-based pressure pack lubricants are not recommended.

Figure A shows the head assembly being pulled off the shaver body. Figure B shows the head being rinsed under a tap.

REPLACING SHAVING HEADS & CUTTERS

Refer to the specifications table for the correct replacement part number (SP-HC7500AU-BA). Replace shaving heads and cutters every 12 months for optimal performance and to prevent irritation.

Signs of wear include:

• Irritation: Increased skin irritation as heads wear, especially when applying lotion.
• Pulling: A feeling of pulling or loss of closeness during shaving indicates it's time for replacement.

Keep the neck of the head shaver when replacing heads and cutters. Replacement parts can be obtained from local retailers or directly from Remington® by filling out the accessory order form or calling the Remington® Service Hotline.

BATTERY REMOVAL

Note: Battery removal should be performed by a professional due to sharp edges on parts and tools.

• The rechargeable battery must be removed before scrapping the appliance.
• Disconnect the charging adapter before removing the battery.
• Ensure the device is fully discharged by switching it on until it stops.
• Remove the head assembly.
• Pry off the front panel using a small screwdriver.
• Pry off and remove the two side panels.
• Pry off the display panel with a small flat screwdriver.
• Unscrew the 4 screws to open the front housing.
• Unscrew the 4 screws and remove the rear housing.
• Pry the battery from the circuit board and disconnect it from the wires.

Dispose of the battery safely. Do not attempt to operate the shaver after opening it.

Dispose of e-waste (appliances with plugs, batteries, or cords) through controlled recycling facilities, not general household waste. Contact your local council for recycling information.

Suitable for use in bath and shower.

This product conforms to radio frequency interference requirements. Any product purchased and used commercially carries a limited 90 Day Warranty.

WARRANTY AGAINST DEFECTS

Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited

This warranty provides benefits in addition to rights under the Australian Consumer Law or the CGA (New Zealand).

• Warranty Period: Three (3) years from the date of purchase for all parts defective in workmanship or materials.
• Warranty Conditions:
• The Goods must be used according to manufacturer's instructions. This warranty does not cover defects due to misuse, abuse, accident, or non-observance of instructions.
• Consumable parts (shaver heads, cutters, foils) are covered only if defective in workmanship or materials.
• Repairs or replacements are at the manufacturer's discretion. Replaced parts or products are property of the manufacturer.
• To claim under warranty, retain this warranty with your receipt/proof of purchase and return the Goods via prepaid freight within the Warranty Period, with legible proof of purchase.
• This warranty is void if serial numbers or appliance plates are removed or defaced, or if repairs are done by unauthorized personnel using non-approved parts.
• The Goods are for domestic use only; a limited 90-day warranty applies to commercial use. Ensure the product is connected to the correct voltage.
• This warranty does not cover the cost of claiming or transport of the Goods.
• This warranty is valid and enforceable in Australia (Spectrum Brands Australia Pty Ltd) and New Zealand (Spectrum Brands New Zealand Limited).

CONTACT INFORMATION

Spectrum Brands Australia Pty Ltd
Locked Bag 3004, Braeside, VIC 3195, AUSTRALIA
Customer service: 1800623118
Email: consumer.enquiry@remington-products.com.au
Website: www.remington-products.com.au

Spectrum Brands New Zealand Limited
PO Box 9817, Newmarket, Auckland 1149, NEW ZEALAND
Customer service: 0800736776
Email: info@remington.co.nz
Website: www.remington.co.nz

REMINGTON SERVICE HOTLINE
Australia: 1800623118 (toll free)
New Zealand: 0800736776 (toll free)

AUTHORISED REPAIR CENTRES
Visit www.remington-products.com.au for details.

® Registered Trade Mark of Spectrum Brands Inc., (SBI) or one of its subsidiaries.
© 2022 Spectrum Brands Inc.
Rev. 05/22
Part No. T22-7002634
Type: R29A