ILLUMINATED MIRRORS - LED

Safety Precautions

Please read these instructions carefully before starting installation and keep them in a safe place for future reference.

Check the contents of the pack carefully before installation. Responsibility will not be held for any de-fit / re-fit costs where faulty product has been fitted. If any fault is found with materials or workmanship, it must be reported immediately to the manufacturer. Remedial action will be taken, based on information received, on condition that: 1. Full details are supplied to the manufacturer; 2. The product has not been modified or tampered with; 3. The manufacturer is informed of any damage/shortages prior to installation. 4. The product has not been installed, or attempts have been made to install. Britton does not accept responsibility for any problems that may occur through incorrect installation. ENSURE the room is well heated and ventilated.

Any modification to the supplied product will negate all product guarantees.

Before drilling ensure there are no hidden cables or pipes (water, gas or electrical) behind hanging points. Always wear suitable eye protection when drilling. Ensure the wall surface is able to take the weight of the complete product.

Please use the supplied wall fixing bracket and follow the correct installation method. If the instructions are not followed appropriately there is an increased safety risk to the user. It is important to install light fittings in the correct bathroom zone, i.e. the zone referred to in the IP rating of the element. This is not an installation guide and reference should be made to the latest edition of the IET Wiring Regulations or a qualified electrician member of NICEIC or IET.

Bathroom Zones:

• ZONE 0: Inside the bath or shower tray itself. Any appliance used in this zone must be rated at least IP67 (total immersion proof).
• ZONE 1: The area above the bath or shower tray to a height of 2.25m from the floor. In this zone a minimum rating of IPX4 (Splash-proof) is required and elements must also be protected by a 30mA residual current device (RCD) to protect the circuit.
• ZONE 2: An area stretching 0.6m outside the perimeter of the bath and to a height of 2.25m from the floor. In this zone an IP rating of at least IP44 is required. In addition, it is good practice to consider the area around a washbasin, within a 60cm radius of any tap, to be considered as zone 2.

The electrical connection to the power supply for these appliances must be in Zones 2/3 of the bathroom in compliance with BS 7671:2008(2011) - IET Wiring Regulations.

Appliance must also be protected by a 30mA residual current device (RCD) to protect the circuit.

It is recommended that all electrical bathroom products should only be fitted by a suitably qualified, Part P registered electrician in accordance with current IEE regulations. Failure to have electrical products installed and certificated by a qualified electrical engineer will invalidate any product guarantee. For full details, reference should be made to the latest copy of the IET wiring regulations and all applicable British Standard and European norm specifications.

This product is IP44 rated and is suitable for installation within zone 2 above, and complies with the following safety standards: EN 60598-2-1:1989, EN 60598-1:2015, EN 62493:2015

INSTALLATION INSTRUCTIONS

It is recommended that walls are fully tiled/finished before installation. This ensures that the product is installed flat to the wall face and allows the product to be easily removed if required in the future.

OPERATING INSTRUCTIONS

To turn illumination on, touch the sensor once.

To change the colour temperature, touch and hold the sensor until the desired light temperature (warm or cool) is obtained.

The colour temperature is then set until changed again.

This product contains a light source of energy efficiency class <E>.