Shuttle XPC Accessory PRC01

Expansion Kit PRC01 for XPC Slim XH510G2/XH610G2 - Power Supply Upgrade for Graphics Cards

The PRC01 expansion kit includes a PCIe riser card and two adapter cables. Installing this accessory in the Shuttle XPC slim XH510G2 or XH610G2 allows for a second external power adapter to be connected, enabling the use of more powerful graphics cards. By default, graphics cards with a maximum power dissipation of up to 75 watts can be supplied via the PCIe slot. With PRC01, the graphics card can be supplied with additional power via an internal 6- or 8-pin power connector.

Note: The second power adapter (e.g. Shuttle PE180) is not included with PRC01.

Optional accessory: Shuttle PE180 (180W power adapter)

Contents:

• PCIe Riser Card
• DC adapter cable for power adapter
• Internal power cable for the graphics card with 6+2 pin connector
• Quick Installation Guide
• Note: the power adapter is not included (e.g. Shuttle PE180)

Compatibility

The PRC01 riser card is intended to be installed in the Shuttle XPC slim XH510G2 or XH610G2.

Which Power Adapter Can Be Used?

• A power adapter is not included with PRC01.
• The 4-pin DC connector supports power supplies with these output characteristics:
  • output voltage: 19.5 V
  • max. output wattage: 270 W
• When using the supplied DC cable adapter, commercially available 90W or 180W power supplies with 2.5/5.5 mm DC connector can be used (see table below).

Graphics Card Power Cable

The PRC01 kit provides an internal power cable for the graphics card which has a flexible 6+2 pin connector. This means, it can be connected to graphics cards with 6-pin or 8-pin power connector.

Configuration Examples for XH510G2/XH610G2 with Graphics Card:

Note: the maximum length of the graphics card is 20.8 cm, max. width: 45 mm (Dual Slot)

Installation Guide

PRC01 Scope of Delivery:

• (1) Power extender cable for power adapter
• (2) Molex Power cable for graphics card
• (3) Riser Card
• (4) Installation Guide

[Image showing the PRC01 kit components labeled 1, 2, 3, 4]

Due to safety reasons, please turn off your computer completely first and unplug it from the power supply.

Step 1

Unscrew the two thumbscrews of the chassis cover, slide the cover backwards and upwards. Use a 6-mm screwdriver to puncture the perforated hole on the back panel from the outside in. Once the screwdriver passes through the perforation, carefully remove the metal tag.

Step 2

As shown, take out the standard riser card from the system and unfasten the screws of the bracket, then switch the bracket to the riser card (PRC01) and fasten screws.

Step 3

Connect the Molex power cable to the riser card (PRC01) with the 6-pin side and install it into the system. After finishing the graphics card installation, please connect the Molex power cable with the 6-pin or 6+2-pin connector on the graphics card by the 6+2-pin side. (Please refer to the XH510G2 Quick Guide when installing the graphics card)

Step 4

Replace the back cover and refasten the screws.

Step 5

Plug the Power Extender Cable into the 4-pin "Ext. 19V" connector. On the other side of the cable is a 2.5/5.5 mm connector for a second power adapter, which must be purchased separately (e.g. Shuttle PE180).