User Manual for Guangzhou Itech Electronic Technology models including: IX-E01, IXE01, 2A7AR-IX-E01, 2A7ARIXE01, IX-E01 Flame LightS Speaker, Flame LightS Speaker
Guangzhou iTech Electronic Technology Co.Ltd IX-E01 FLAME LIGHT SPEAKER 2A7AR-IX-E01 2A7ARIXE01 ix e01
FLAME LIGHT SPEAKER IX-E01 USING YOUR SPEAKER 1.Flamelight ess the Light On/Off button to turn the light on or off. Short press to adjustthe mode of the light Flicking/Candle/Always On 2. Play Music/Answer a Call. Short press the Play/Pause button to play a track or to answer an incoming call. Press it again to pause a tack orendocall.Pess and hold the Play/Pause buttan to reject an incaming call 3. Button"+": Tap once ta increase the volume.Press and hold ta advance ta the next track in a playlist 4.Buttan"-" Tap once to turn down the volume. Press and hold to return to the previous in a playlist 5. Bluetooth Press and hold the Bluetooth button to disconnect/reconnect Bluetooth.Tap twice to CSB Mode which supports multi-connect function CHARGING YOUR SPEAKER While charging, red LED light flashes and will go out once charging is complete. MAINTENANCE &CARE -Before using your speaker, inspect the ports to make sure that they are clear of dust and debris before charging -Use a soft clath to clean your speake. Never use any harsh chemicals or detergents. Make sure your speaker is dry before charging -When your speaker is not in use, it should be stored in a cool, dry place. -Never tug or yank on the USB charging cable while it 1s connected to your speaker.Connect and disconnect cables as carefully as possible. -Never expose your speaker to high temperatures, or extreme cold. -Please recycle or dispose of your speaker properly based on the laws and rules of your municipality. Contact local recycling facties and/or the manufacturer of your speake for further information. AOMAIS ONE YEAR WARRANTY This warranty covers the original consumer purchaser only and is not transferable. This warranty coves products that fail to function properly UNDER NORMAL USAGE, due to defects in material o WOkmanship. Your product will be epaired or replaced at no charge for parts or labor for a period of one year. What Is Not Covered by Warranty Damages or malfunctions not resulting from defects in material or workmanship and damages or malfunctions fom otherthan normaluse,including but not limited to repair by unauthorized parties,tampering, modification or accident. To Obtain Warranty Service and Troubleshooting Information: Email support@aomais.com or visit our website at https://www.aomais.com FCC Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Acrobat Distiller 18.0 (Windows)