User Guide for SYLVANIA models including: SP667-B-BLACK 16 Inch Long Bluetooth Speaker, SP667-B-BLACK, 16 Inch Long Bluetooth Speaker
| Sylvania
Manuals & | Sylvania
| Sylvania English Manual:
TJ[F9NN M -B-BLACK_FD M and record music and record music After the portable speaker is turned on, insert the TF Card or U disk to the TF/USB port, it will switch to TF / USB mode and start playing the music, the Bluetooth mode will be disconnected. Long press the volume to adjust the volume level, short press the volume to adjust the previous track and nex track. record music After the portable speaker is turned on, insert the TF Card or U disk to the TF/USB port, press the bluetooth button and turn to the bluetooth mode, connect your device to paly the music , long press the bluetooth button around 3 seconds you will here a prompt voice "ding" means the TF card/USB is start recording , long press the bluetooth button 3 seconds again and you will here prompt voice"ding ding" to stop recording . Note : a) During recording, if there is a phone call incoming , the recording will be stopped b) When your TF card and U disk insert to the speaker at same time , it will record to your U disk when recording. c) The recording only works in bluetooth mode, can not record in FM and Aux in mode . NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. For service assistance and product information, please call: 1-800-968-9853. Curtis International Ltd. 7045 BECKETT DRIVE, UNIT 15, MISSISSAUGA, ON, L5S 2A3 www.curtisint.comAdobe Illustrator CS5 Adobe PDF library 10.01