VEVOR

NEED HELP? CONTACT US!

Have product questions? Need technical support? Please feel free to contact us:

CustomerService@vevor.com

This is the original instruction. Please read all manual instructions carefully before operating. VEVOR reserves the right to interpret its user manual. The appearance of the product is subject to the product received. VEVOR will not provide further notice for technology or software updates.

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of fire, explosion, electric shock, or injury when using your ice maker, follow these important safety instructions:

• Before using, check that the voltage power corresponds to the one shown on the appliance nameplate.
• Do not remove any safety, warning, or product information labels from your ice maker.
• Plug the ice maker into an exclusive grounded power outlet. No other appliance should be plugged into the same outlet. Be sure that the plug is fully inserted into the receptacle.
• This appliance must be grounded. It is equipped with a power cord having a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
• Avoid using an extension cord because it may overheat and cause a fire risk. However, if it is necessary to use an extension cord:
  • Use only an extension cord with a grounding plug.
  • The marked rating of an extension cord must be equal to or greater than the rating of this appliance.
  • It should be positioned such that it does not drape over the counter or tabletop where it can be pulled on by children intentionally.
• Do not operate any appliance with a damaged cord or plug or after the appliance malfunction or has been damaged in any manner. Return the appliance to the nearest authorized service facility for examination, repair or adjustment.
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
• Do not let the cord hang over the edge of the table or counter.
• Do not place on or near a hot gas or electric burner, or in a heated oven.
• Place power cord in such a way it cannot be pulled on by children or cause a tripping hazard.
• Place power cord in such a way that it is not in contact with hot surfaces.
• The use of attachment not recommended or sold by manufacturer may cause fire, electric shock or injury.
• Do not touch the evaporator when using the ice maker or making ice to avoid frostbite.
• Do not immerse any part of the product in water.
• To disconnect, turn any control to "OFF", then remove plug from wall outlet.
• Do not plug or unplug product with wet hands.
• Unplug the product before cleaning, maintaining, and when not in use.
• Do not use microbiologically unsafe water or of unknown quality.
• Do not clean your ice maker with any flammable fluids. The fumes may create a fire hazard or explosion.
• Do not overturn the ice maker. If the ice maker is overturned accidentally, make it stand steadily for 2 hours before powering it on again.
• If the ice maker is brought in from outside in wintertime, do not use for a few hours, allowing the unit to warm up to the room temperature before operating.
• Never put flammable, explosive and corrosive articles into the ice maker.
• Never use the ice maker when there is flammable gas leakage.
• Never store or use gas and other flammable articles near the ice maker to avoid any fire.
• Unplug the ice maker before moving it to avoid damaging the refrigerating system.
• Do not attempt to disassemble, repair, modify, or replace any part of your product.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• Close supervision is necessary when any appliance is used by or near children.
• Do not leave the appliance unattended while in use.
• Do not use outdoors.
• Do not use the appliance for other than intended use.
• Please abandon the ice maker according to local regulators as it uses flammable blowing gas and refrigerant.
• Please dispose of the appliance for its flammable refrigerant and blowing gas according to local regulations.
• WARNING: Keep ventilation openings in the appliance enclosure or the built-in structure clear of obstruction.
• WARNING: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
• WARNING: Do not damage the refrigerant circuit.
• WARNING: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer.
• Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
• ⚠️ Warning: Risk of fire/flammable materials.
• WARNING: When positioning the appliance, ensure the supply cord is not trapped or damaged.
• WARNING: Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance.

SAVE THESE INSTRUCTIONS HOUSEHOLD USE ONLY

KNOW YOUR ICE MAKER

BEFORE FIRST USE

1. Unpack the appliance, then check and make sure that all the accessories, including the ice basket and ice scoop, etc., are complete. Please contact the client service department if some accessories are missing.
2. Please ensure the ice maker is level and on a stable table or platform to avoid malfunction.
3. The incline angle of the ice maker cabinet should not exceed 45° during transportation or use. Do not turn the ice maker upside down. Doing so could cause the compressor or refrigerating system to operate incorrectly. Please allow time for the fluids in the compressor to settle after the ice maker is moved or transported. Before using the ice maker for the first time, please wait for 2 hours after the unit has been leveled and positioned in the proper place.
4. The appliance must be placed on a dry and level surface with sufficient ventilation, far from heat sources such as ovens, heaters and corrosive gases. Leave about a 6-inch (15cm) clearance on all sides of the ice maker for proper ventilation.
5. Do not fill the water reservoir with hot water. This may damage the ice maker. It is best to fill the water reservoir with water of room temperature or lower.
6. Do not use the appliance in a cold environment (lower than 5°C).
7. Clean the appliance by following the operation of "CLEANING AND MAINTENANCE" before operating.

USING YOUR ICE MAKER

1. Ensure that the drain plug at the bottom of the water reservoir is closed well.
2. Plug the ice maker into the wall outlet; the [Power Indicator] indicator blinks. NOTE: Please rest the ice maker for 30 minutes before plugging if it has been moved.
3. Open the top lid and remove the ice basket.
4. WARNING: Fill the water reservoir with potable water only. NOTE: Do not fill above the MAX water level mark.
5. Replace the ice basket and close the top lid.
6. Press the [SELECT Button] to select the ice size; [Small Ice Indicator] means small ice, while [Large Ice Indicator] means large ice.
7. Press the [ON/OFF Button], and the [Power Indicator] indicator lights solidly.
8. The ice-making cycle will last approximately 7-15 minutes, depending on the ambient temperature and water temperature.
9. The ice-making cycle starts with water being pumped into the ice tray situated below the evaporator. Over the next 7-15 minutes, ice forms on the evaporator. Once this has completed, the ice tray will tilt backwards, and the remaining water in the ice tray is drained back into the water reservoir. The ice cubes are then dropped from the evaporator and pushed forward into the ice basket by the ice shovel. The ice tray will automatically move back into position under the evaporator and start the next cycle.
10. The [F Indicator] will light up when the ice basket is full, and then the ice maker will stop the ice-making cycle automatically. Gently remove the ice from the ice basket with the ice scoop. About 5 seconds later, the ice maker will restart its ice making function automatically.
11. The [Water Drop Indicator] will light up when the water reservoir is lack of water, and the ice-making cycle will stop automatically. At that time, remove the ice basket and add water to the water reservoir, and then press the [ON/OFF Button] again to restart the ice-making cycle. The [Water Drop Indicator] will not light up if the Ice Maker is operated under the condition that it is supplied with water continuously.
12. When you have got your desired amount of ice, stop the ice making cycle by pressing the [ON/OFF Button] and unplug the unit from the wall outlet.
13. Open the top lid and transfer the ice to a freezer. NOTE: The ice will last in the ice maker for up to an 18-hour period, depending on the ambient temperature.
14. Allow the ice maker to warm up to room temperature.
15. Suggest replacing the water every week. Please empty the water reservoir if the ice maker is not used for a long time.

CLEANING AND MAINTENANCE

To keep your ice tasting fresh and your ice maker looking great, we recommend cleaning your ice maker at least once per week.

1. Stop the ice-making cycle by pressing the [ON/OFF Button], unplug the ice maker from the wall outlet, and allow it to warm up to room temperature.
2. If residual water is found in the ice tray, gently push the ice tray back so that all water drains into the water reservoir.
3. Move the appliance forward to a place 60mm away from the working table and open the drain plug to drain out excess water (see Fig.1, Fig.2 and Fig.3).
4. Check and make sure the drain plug is closed well. Fill the water reservoir with clean water, press the [SELECT Button] until the [Clean Indicator] flashes, then press the [ON/OFF Button]. The pump will start to pump water and run for 6 minutes, then enter standby condition. Finally, open the drain plug and empty the water.
5. Remove the ice basket.
6. Clean the ice maker interior with a soft cloth soaked with warm water and vinegar, then rinse with clean water and drain all the water.
7. Replace the drain plug in position. Wash the ice basket and ice scoop in warm soapy water. Rinse and dry.
8. Clean the exterior of the ice maker with a soft damp cloth. Use a mild dishwashing soap, if necessary.
9. NOTE: Do not use organic solvent, boiled water, detergent, strong acid, and strong alkali etc. for cleaning.
10. Please empty the water reservoir and dry it for storage if the ice maker is not used for a long time.

TROUBLESHOOTING

TECHNICAL PARAMETERS

Model:

IM2200DA-UL

Ice Production:

33 lbs/day

Applicable climate:

ST/SN/N/T

Class:

I

Electrical Rating:

AMP 1.8A 120V AC 60HZ

Rated power:

130W

Refrigerant/Refrigerant amount:

R600a/25g

Foaming agent:

C5H10

Net weight:

11Kg

Housing:

SUS430

Unit size(WXDXH):

L 400×W 246×H 430mm