Introduction and Safety Information
Welcome to your new JENSEN stereo cassette player with AM/FM radio. This manual will guide you through its operation and features to maximize your enjoyment.
Hearing Safety
JENSEN and the Electronic Industries Association's Consumer Electronics Group recommend avoiding prolonged exposure to excessive noise to protect your hearing. Set your equipment at a safe listening level. Start with the volume low and slowly increase it until you can hear comfortably and clearly, without distortion. Once a comfortable level is found, set the dial and leave it there. This practice helps prevent hearing damage or loss.
WARNING: Extended play at very high volume may impair your hearing. If you experience ringing in your ears, reduce the volume or shut off the unit. Do not use while driving a motorized vehicle, as this is dangerous and illegal in some states. Even with open-air headsets, excessively high volume may still block outside sounds.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B Digital Device, designed to provide reasonable protection against harmful interference in a residential installation. If interference occurs, try reorienting the antenna, increasing separation between equipment and receiver, or connecting to a different circuit. Consult a dealer or technician if problems persist.
WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Customer's Record
Record your product's serial number here for future reference:
Model Number: SCR-75
Serial Number: ____________________
Location of Controls
Familiarize yourself with the controls:
- 1. CASSETTE DOOR: Opens to insert/remove cassette tapes.
- 2. STOP BUTTON [■]: Stops cassette playback or fast forward.
- 3. PLAY BUTTON [▶]: Starts cassette playback.
- 4. FAST FORWARD BUTTON [>>]: Advances tape quickly.
- 5. VOLUME CONTROL: Adjusts the sound level.
- 6. FUNCTION SELECTOR: Switches between RADIO and TAPE modes.
- 7. DIAL SCALE: Displays radio frequencies (FM 88-108 MHz, AM 530-1710 kHz).
- 8. STEREO HEADPHONE JACK: Connects included earbuds or other headphones.
- 9. LINE-OUT JACK: For connecting to external audio systems.
- 10. DETACHABLE BELT CLIP: For portability.
- 11. TUNING CONTROL: Selects radio stations.
- 12. AM/FM BAND SELECTOR: Chooses between AM and FM radio bands.
- 13. DC JACK: For connecting an optional AC adapter.
Visual Description of Unit: The unit is a portable, rectangular cassette player with a textured dark grey casing. A transparent oval window on the front allows viewing of the cassette tape. Controls are located on the top and sides. The front features the JENSEN logo and the dial scale for radio tuning. The sides have buttons and jacks. The back houses the battery compartment and belt clip.
Power Source
The SCR-75 can be powered by two 1.5V DC "AA" size (UM-3) alkaline batteries (not included) or an optional AC-DC adapter (3V DC ~ 600mA output, not included).
Battery Operation
- Open the battery door on the back of the unit.
- Insert 2 'AA' (UM-3) batteries, observing the polarity diagram (+ and -) inside the compartment.
- Close the battery door.
IMPORTANT: Ensure batteries are installed correctly. Incorrect polarity can damage the unit and void the warranty.
Notes:
- For best performance and longer operating time, use good quality alkaline batteries.
- Replace batteries when the volume level significantly decreases, sound becomes distorted, or the unit no longer functions properly.
BATTERY WARNING:
- Ensure batteries are installed correctly; wrong polarity may damage the unit.
- Use only the specified battery size and type.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
- If the unit will not be used for an extended period, remove the batteries to prevent damage from leaks.
- Do not attempt to recharge non-rechargeable batteries; they may overheat and rupture. Follow battery manufacturer's directions.
- Do not dispose of batteries in fire, as they may leak or explode.
AC Adaptor Operation
- Plug the AC adapter cord into the DC IN JACK (#13) on the SCR-75.
- Plug the AC adapter into a household 120V/60Hz AC power outlet.
- When the AC adapter is plugged in, the batteries are automatically disconnected, and the unit operates on AC power.
NOTE: Use only an adapter with an output voltage rated at DC 3V 600mA with a center positive plug [Θ].
Operation
Radio Operation
- Plug the included earbuds into the STEREO HEADPHONE JACK (#8) and place them in your ears.
- Set the FUNCTION SELECTOR (#6) to “RADIO”.
- Set the AM/FM BAND SELECTOR (#12) to "AM" or "FM" for your desired band.
- Rotate the TUNING CONTROL (#11) to select a radio station.
- Adjust the VOLUME CONTROL (#5) for the desired sound level.
- To turn the radio off, switch the FUNCTION SELECTOR (#6) to “TAPE”.
Tips for Best Radio Reception
- For maximum FM reception, keep the earbud cord fully extended, as it acts as an external FM antenna. Do not wind or fold it.
- For maximum AM reception, place the unit in a vertical position and slowly turn the unit while tuning until the best reception is obtained.
Cassette Player Operation
- Plug the included earbuds into the STEREO HEADPHONE JACK (#8) and place them in your ears.
- Set the FUNCTION SELECTOR (#6) to “TAPE”.
- Open the CASSETTE DOOR (#1). Insert a pre-recorded cassette tape with the exposed tape facing upwards, then close the door.
- Press the PLAY BUTTON [▶] and adjust the VOLUME CONTROL (#5) for the desired sound level.
- Press the FAST FORWARD BUTTON [>>] to advance the tape quickly.
- Press the STOP BUTTON [■] to stop playback.
Auto Stop System
This unit features an Automatic Stop System to protect your cassette tapes and the pinch roller. When the tape ends during playback or fast forwarding, the PLAY BUTTON [▶] will automatically release, stopping the cassette.
Cassette Tape Operating Tips
- High-quality tapes are recommended for optimal sound reproduction.
- Tapes with a playing time of 120 minutes (C-120) are not recommended due to their thinner tape, which increases the chance of malfunction and jamming, potentially damaging the mechanism.
- For good reproduction, clean the tape head after every 10 to 20 hours of use.
- Keep cassettes away from excessive heat or cold.
- If there is slack in the tape, remove it before inserting the cassette. To remove slack, insert a pencil into the cassette hub and rotate clockwise.
- A leader tape is present at the beginning of each cassette; this area has no recording. Let the tape run for about five seconds to clear the head.
- Keep the tape head clean. A dirty head can cause distorted sound or improper tape speed. Clean the tape head, capstan, and pinch roller using a cotton swab with tape head cleaner or alcohol while the PLAY BUTTON [▶] is depressed.
Connections and Maintenance
Line-Out Connection
The SCR-75 has a 3.5mm stereo LINE-OUT JACK (#9) that allows connection to your home stereo system or external amplified speakers using a stereo audio cable (not included). The audio cable requires a 3.5mm stereo plug for the SCR-75 and appropriate plugs for the input device. When connected externally, the SCR-75's volume control will not affect the output volume; use the volume control on the external device.
Care and Maintenance
- Clean the unit with a damp (never wet) cloth. Do not use solvents or detergents.
- Avoid leaving the unit in direct sunlight, or in hot, humid, or dusty places.
- Keep the unit away from heating appliances and sources of electrical noise, such as fluorescent lamps or motors.
Troubleshooting Guide
If you experience difficulties, check the following or call 1-800-777-5331 for Customer Service and support.
| Symptom | Possible Cause | Solution |
|---|---|---|
| No sound | Low or no power | Replace all batteries with new ones. |
| Sound appears distorted at high volume setting | Volume set at minimum | Increase Volume. |
| Volume control is set to maximum | Adjust Volume control to a lower comfortable level. | |
| Noise or distorted sound on FM broadcasts | Earbuds cord is not extended | Unwrap and fully extend the earbuds cord. |
| Radio - no sound | The unit is not in Radio mode | Switch to Radio mode. |
| The station is weak | Retune the station again. | |
| Cassette Player - no sound | The unit is not in TAPE mode | Slide the function selector to TAPE. |
| Volume at minimum | Increase volume. | |
| Tape Sound distorted | Defective tape or dirty tape head | Replace tape or clean tape head. |
| Speed varies | Tape old or worn | Replace the tape. |
| Dirty roller and capstan | Clean roller and capstan. |
Specifications
Power Requirement: Battery: 2 x "AA"(UM-3) batteries (not included); AC Adaptor (not included): Input: AC 120V ~ 60Hz, Output: DC 3V 600mA [Θ]
AM Frequency: 530 KHz – 1710 KHz
FM Frequency: 88 MHz – 108 MHz
Spectra Green Notice
At Spectra, environmental and social responsibility is a core value. We are dedicated to continuous implementation of responsible initiatives to conserve and maintain the environment through responsible recycling. Please visit us at http://www.spectraintl.com/green.htm for more information on Spectra's green initiatives or to find a recycler in your area.
Warranty and Support
90 Day Limited Warranty and Service (Valid in the U.S.A. ONLY)
SPECTRA MERCHANDISING INTERNATIONAL, INC. warrants this unit to be free from defective materials or factory workmanship for 90 days from the original purchase date, provided it is used within the U.S.A. This warranty is not transferable. The obligation is limited to repair or replacement of the defective unit or part (excluding batteries). Proof of purchase is required.
Customers must pay all shipping charges to SPECTRA for warranty service. Return charges for repaired/replaced items are at SPECTRA's expense. No other express warranties are provided.
Warranty conditions include: possession by original purchaser with proof of purchase, no accident, misuse, abuse, improper service, or non-SPECTRA approved modifications, and claims made within the warranty period.
The warranty does not cover damage from non-compliant electrical wiring or failure to provide reasonable care and maintenance as outlined in the manual. It applies to residential use only and is void for non-residential environments or outside the United States.
To Obtain Service: Remove all batteries, pack the unit carefully, and send it freight prepaid to SPECTRA Service Department. Include a copy of your dated sales receipt for warranty eligibility. Provide a note describing the defect and your contact information (name, address, phone number, email) for status updates.
Out of Warranty Service: Include a check for $10.00 to cover repair, handling, and return postage. All out-of-warranty returns must be sent prepaid.
For updated information or service inquiries, contact SPECTRA at 1-800-777-5331 or custserv@spectraintl.com. SPECTRA reserves the right to offer alternative options if the model is discontinued.
SPECTRA MERCHANDISING INTERNATIONAL, INC.
4230 North Normandy Avenue,
Chicago, IL 60634, USA.
1-800-777-5331
To register your product, visit: http://www.spectraintl.com/wform.htm
Spectra Merchandising International, Inc. - Product Registration - United States
