USUB 雲斯 - 科技智能產品網購 各弱電系統工程
User Manual for USUB models including: SC01-30AU-LT-F, Laptop and Tablet Charging Cart, SC01-30AU-LT-F Laptop and Tablet Charging Cart
Death or serious injury may occur when children climb on audio and/or video equipment furniture. A remote control or toys placed on the furnishing may encourage a child to climb on the furnishing and as a result the
This cart is intended for use only with loading as indicated. Use with loads greater than indicated may result in instability Please place the devices from the bottom to top shelf to avoid the tilting
File Info : application/pdf, 7 Pages, 1.63MB
DocumentDocumentwww.usub.hk User Manual Charging Cart Copyright 2021 USub all rights reserved 1 www.usub.hk WARNING ALWAYS FOLLOW SAFETY CAUTION This cart is intended for use only with loading as indicated. Use with loads greater than indicated may result in instability Please place the devices from the bottom to top shelf to avoid the tilting Death or serious injury may occur when children climb on audio and/or video equipment furniture. A remote control or toys placed on the furnishing may encourage a child to climb on the furnishing and as a result the furnishing may tip over on to the child. Relocating audio and/or video equipment to furniture not specifically designed to support audio and/or video equipment may result in death or serious injury due tothe furnishing collapsing or overturning onto a child. DO NOT allow anyone to sit, stand or climb on the cart. DO NOT lift the cart. DO NOT block the ventilation holes used for air circulation. When moving the cart, DO NOT put any devices (ex: TV, Monitor, Document's camera...etc.) on top of cart. No TV/monitor is to be used on top of cart. Before moving the cart, disconnect the power from the wall outlet. While moving the cart, make sure the power cord is secured and tightly wrapped. Copyright 2021 USub all rights reserved 2 www.usub.hk Introduction Cart Dimensions Model Description Dimension W*D*H (mm) Laptop & Tablet Charging Cart, Charging Type: AC + USB charging SC01-30AU-LT-F 30(10*3) devices, with fast charging 820*650*1257.5 SC01-40AU-LT-F 40(10*4) devices, with fast charging 820*650*1587.5 Tablet Charging Cart, Charging Type: USB charging only SC01-30A-T-B 30(10*3) tablets, without fast charging 620*600*1022.5 SC01-36A-T-B 36(12*3) tablets, without fast charging 684*600*1022.5 SC01-40A-T-B 40(10*4) tablets, without fast charging 620*600*1262.5 SC01-48A-T-B 48(12*4) tablets, without fast charging 684*600*1262.5 SC01-64A-T-B 64(16*4) tablets, without fast charging 812*600*1262.5 Note: This dimension includes casters and handles Cart Diagram Front Back Copyright 2021 USub all rights reserved 3 Setup USB charging operation 1. Disconnect the charger in advance and open the cabinet door. 2. According to the tablet number, put the tablets one by one into the tablet rotation slot corresponding to the number. 3. The two ends of the USB cable are connected to the charging HUB port on the device and the tablet port respectively. 4. After the connection is completed, lock the cabinet door and plug the power plug of the charging car into the mains outlet for charging 5. Switch the main power switch to "ON", and then all charging units' LED charging status indicator lights up red, and the device is in charging state. Copyright 2021 USub all rights reserved www.usub.hk 4 AC charging operation with adapter 1. Disconnect the charger in advance and open the rear door. 2. Plug your tablet or laptop charger into the socket at the back of the car one by one, then thread the cable through the hole; For laptop charges, place the adapter in the bucket below the thread hole. 3. Open the front door of the charging car. 4. Jam the data line with the buckle and arrange the data line. 5. Place tablets or laptops one by one in the tablet (laptop) slot and connect to the corresponding data cable 6. After the connection is completed, lock the cabinet door, and plug the power plug of the charging car into the mains outlet for charging 7. Switch the main power switch to "ON", and then all charging units are in charging state Copyright 2021 USub all rights reserved www.usub.hk 5 Specifications Service environment Working temperature 0~45 Working environment humidity 20%~80% Humidity of storage environment -15~45 The machine has passed CE certification and RoHS certification www.usub.hk Product Parameter Main material Input Product power Cooling system Output Status indicator light External AC socket System compatibility Super compatible The main body adopts 1.0mm-1.5mm cold-rolled steel plate. The main frame adopts high strength aluminum profiles, the cabinet is provided with ABS engineering plastic partition layer, layering the tablet is effective in preventing scratches AC 220-240V 50Hz 16A 3500W Forced air cooling USB: 5V 2.1A AC: 220-240V 50Hz 13A Red light: in charging state; Green light: full/disconnected Standard: BS1363 socket*1pc Android system, iOS system, Windows System 1. Other Android devices 2. Other mobile terminals 3. V+/V-No agreement class Copyright 2021 USub all rights reserved 6 www.usub.hk Contact Us Email: info@usub.hk Phone/WhatsApp: +852 62545444 Address: Flat E, 14/F Century Industrial Building, 1 Tsing Yeung Circuit, Tuen Mun, N.T. Hong Kong Working hours: 9am-6pm, Monday to Friday (Except public holidays) Copyright 2021 USub all rights reserved 7