User Guide for JBL models including: Stage XD6 Indoor-Outdoor Speakers, Stage XD6, Indoor-Outdoor Speakers, Speakers
JBL JBLXD6WHT 0050036389808
JBL Stage XD6 6.5" 2-Way Indoor/Outdoor All-Weather Loudspeakers (Pair) Black JBLXD6BLK - Best Buy
Stage XD Indoor/Outdoor Speakers EN Quick Start Guide Overview This Quick Start Guide contains basic information on the Stage XD Indoor/Outdoor loudspeakers, important preinstallation steps, and important safety warnings about installation of this product. Read through this document in its entirety before proceeding with installation. After reading this document visit the product page on the JBL Specialty Audio website for complete installation instructions for these products. Supported Products This document supports the following products. Stage XD-5 2-way 5.25 inch All Weather Loudspeaker Stage XD-6 2-way 6.5 inch All Weather Loudspeaker Box Contents 2x Stage XD-5 or XD-6 Loudspeakers 2x Zero Bezel Grilles 4x Rubber Feet 1x Grille Removal Tool 2x Wall Installation Kit (Mounting Bracket) 1x Quick Start Guide (This Document) IMPORTANT! HARMAN International assumes no responsibility for improper installation of hardware, any personal injuries, or product damages resulting from improper installation or a fallen loudspeaker. Read through this document and other documents associated with this product in their entirety and heed all warning before proceeding with the installation of these product(s). IMPORTANT! Installation Precautions Due to the nature of this product, there are several precautions to follow before installation can begin. 1. Ensure that all wire run inside of walls and ceiling meets or exceeds local fire codes for hidden wiring. 2. Determine wire lengths and select the proper gauge speaker wire to use based on the table under Wire Gauge by Distance. 3. Do NOT connect the speakers to an amplifier rated above the recommended amplifier power. Overdriving the speaker can cause an overheating condition increasing the risk of injury. 4. Do NOT connect the amplifier end of the wire until all speakers are wired and installed. Wire Gauge by Distance Distance/Length Wire Gauge < 50ft (15m) 16AWG 50ft (15m) ~ 100ft (30m) 12AWG >100ft (30m) 10AWG ©2022 Harman International Industries | Specifications, Appearance, and Features subject to change without notice. Rev 1.4 20221117 | Part No. 950-0608-001 Pg 1 Wall Installation The Stage XD speaker can be installed on a wall using the included Wall Installation Hardware. Follow the instructions carefully to ensure proper installation. 1. Install lock nut [A] onto threaded knuckle [C] away from the end. 2. Slide lock ring [B] over threaded knuckle [C]. 3. Secure lock nut [A] onto speaker. 4. Locate mounting position on wall leaving enough space for speaker to clear ceiling and/or other obstacles. Secure knuckle joint [D] to wall with the included security cable [E] on one of the bottom screws. 5. Install the knuckle [C] into the joint [D] and secure lock ring [B]. A A B D B C E Adjusting Angle and/or Orientation Once the speakers are installed on the wall they can be adjusted for angle and orientation. Simply loosen the lock ring slightly and move the speaker within the mount into the desired orientation. Note that for horizontal orientation the logo can be rotated. Tabletop Installation While the common use is to install Stage XD speakers onto a wall, they can also be used on a table/desktop. To use on a flat surface, install the included rubber feet onto the bottom of each speaker at the rear outer corners. FFeeeett LLooccaattiioonn Connecting Speakers 1. Ensure that the appropriate wire gauge has been run based the Wire Gauge by Distance chart. 2. Ensure that wires are marked for polarity to ensure speakers are not connected out of phase. 3. Connect positive wires to the (+) terminal and negative feed wire to the (-) terminals. 4. Continue connecting until all speakers are connected. Specifications Stage XD-5 Stage XD-6 High Frequency Transducer 1" (25mm) Aluminum dome with HighDefinition Imaging (HDITM) waveguide 1" (25mm) Aluminum dome with High-Definition Imaging (HDITM) waveguide Low Frequency Transducer 5.25" (130mm) Polycellulose cone woofer 6.5" (165mm) Polycellulose cone woofer Nominal Impedance 6ohms 6ohms Sensitivity (2.83V@1m) 86dB 88dB Recommended Amplifier Power 20-100W RMS 20-100W RMS Frequency Response (-6dB On-Axis) 75Hz-25kHz 55Hz-25kHz Crossover Frequency 2500kHz Dimensions HxWxD 9.84in (249.9mm) x 7.17in (182.1mm) x 6.37in (161.8mm) 2500kHz 11.77in (299mm) x 8.73in (221.8mm) x 7.64in (194.1mm) Wall Mount Length H: 2.8 (71mm) H: 2.8 (71mm) Harman International Industries, Incorporated. 8500 Balboa Blvd, Northridge CA 91329 United States. European Representative: Harman International Industries, Incorporated. EMEA Liaison Office, Danzigerkade 16G, 1013 AP Amsterdam, The Netherlands. UK Business Address: Ground Floor, Westside 2, London Road, Apsley, Hemel Hempstead, Hertfordshire, HP3 9TD, United Kingdom. © 2022 Harman International Industries, Incorporated. All Rights Reserved. JBL is a trademark of Harman International Industries, Incorporated registered in the United States and other countries. Features, Specifications, and Appearance subject to change without notice. Stage XD Indoor/Outdoor Speakers Quick Start Guide | Rev 1.4 20221117 | Part No. 950-0608-001Adobe InDesign CS5.5 (7.5) Adobe PDF Library 9.9