Installation Guide for AURORALIGHT models including: RDL331103, RDL331203, RDL331103 RDL331203 Series Centro, RDL331103 RDL331203 Series, Centro
RDL331103 Centro – Auroralight
CENTRO INSTALL GUIDE RDL331103 / RDL331203 INSTRUCTIONS: 1. To prevent electrical shock, disconnect transformer from electrical supply and make sure power supply is completely off before installation. Fixtures should always be installed by a licensed electrician. 2. Drill a 2-3/4" hole in the desired mounting location with a max thickness of ¾" (see figure). 3. Separate the 2-conductor 18AWG lead wires by pulling apart the ends to desired length. Strip about ½" of the insulation off the ends (see figure). 4. Pull the main supply cable through the hole, strip insulation off ends, and connect them to the 18AWG lead wires using UL listed wire connectors suited for the location. Neatly return the connected wires back into the hole (see figure). 5. Compress the springs on the side of the fixture by hand and slide it up into the 2-3/4" hole. Take caution to not release the springs until the fixture is in the hole and fingers are clear of the area. 6. Apply light upward pressure to the fixture until it is flush with the mounting surface and springs are fully seated and holding it in place. UL LISTED WIRE CONNECTOR 18AWG LEAD WIRE MOUNTING SURFACE SPRING REQUIRED TOOLS: Wire Cutter / Stripper 2-3/4" Hole Saw MAIN SUPPLY CABLE 3/4" (19mm) MAX THICKNESS 2-3/4" (70mm) HOLE FIXTURE P. 760.931.2910 E. techsupport@auroralight.com O. 2742 Loker Ave. W Carlsbad CA 92010 W. www.auroralight.com WARNING: Luminaire must be installed in accordance with local codes and the National Electrical Code (NEC). Failure to do so may result in serious injury and or damage to the luminaire. WARNING: Risk of electric shock. Install per NEC Code 680.22(B (6), if listed low voltage luminaires are to be located near a pool, spa or fountain.Adobe PDF Library 17.0 Adobe InDesign 19.4 (Windows)