MAHLE PulsarONE eBike Display

Quick Start Guide

1. Step 1: Install / Replace Battery

   Once the battery is installed, the device turns on automatically and the initial setup can be started.

   [Battery installation symbol]

2. Step 2: Set Up

   The device automatically accesses the setup process upon battery installation.

   [Device power-on and setup symbols]

3. Step 3: Pairing

   After initial setup is complete, the search for compatible devices will start by pressing the [M button].

   [Pairing process symbol with M button]

4. Step 4: Power Sensor Calibration

   If the compatible device requires calibration, the process must be completed before starting the ride.

   [Sensor calibration symbol]

5. Display Features Overview

   • Clock: Displays the current time. [Clock symbol]
   • Speed: Shows the current speed. [Speedometer symbol]
   • Battery Level: Indicates the remaining battery charge. [Battery level symbol]
   • Assistance Level: Displays the selected eBike motor assistance level. [Assistance level symbol]
   • System Status: Shows connection status, light status, system errors, lock status, power meter, and heart rate monitor. [System status symbols]
   • Error Code: Displays error codes (e.g., 001-250) if an issue occurs. [Error code symbol]

6. Additional Features

   • Range: Estimated remaining distance the eBike can travel. [Range symbol]
   • Functions: Access to various display functions. [Functions symbol]

GO! - Indicates readiness to start. [GO! button]

Note: When 9:59:59 is reached, all ride metrics are reset automatically.

*Only with iWoc TRIO: Cadence and Watts are displayed.

*An extra sensor is needed for Cadence and Watts.

*Minimum displayable cadence: 30.

Modes and Functions

• Error Mode

  Displays error codes, such as 001-250.

• Lights

  Press and hold the [R button] for 5 seconds to activate or deactivate the lights.

  [Light symbol]

• Access to Menu

  Press and hold the [L button] and [R button] for 3 seconds to enter the menu.

  [Menu access symbol]

• Re-Pairing

  The display automatically pairs with a previously paired eBike. If a previously paired eBike is not detected, the pairing process must be done from the setup menu. If no eBikes are detected for 30 seconds, the screen turns off to save battery. To start a searching process again, short press the [M button].

• Ride Data

  Press any button ([M button], [L button], or [R button]) twice to check the data from your last ride.

  Press and hold the [L button] for 2 seconds to reset the data from your last ride.

• Reset

  The "RESET" function allows resetting ride data. (See Ride Data for details).

• Low Battery

  Indicates when the display's battery is low and needs replacement.

  [Low battery symbol]