Sennheiser BTD 700 Compliance and RF Information

FCC Supplier's Declaration of Conformity (SDoC)

Brand: SENNHEISER

Model No: BTD 700

Manufacturer: Sonova Consumer Hearing USA LLC

This device complies with the requirements of the Federal Communications Commission.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired operation.

For SDoC information, refer to www.sennheiser-hearing.com/download.

ISED Compliance Statement

This device complies with Part 15 of the FCC rules and RSS-247 of Innovation, Science and Economic Development Canada (ISED). Operation is subject to the following two conditions:

• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications made to this equipment not expressly approved by the manufacturer may void FCC authorization to operate this equipment.

RF Radiation Exposure Information

The product complies with the rules of FCC and ISED (RSS-102) for the portable RF exposure limit set forth for an uncontrolled environment and is safe for intended operation as described in this manual. This product is not subjected to FCC routine RF exposure evaluation per Section 2.1093 and RSS-102 of ISED. Further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available.

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. Use of other accessories not verified by the manufacturer may not ensure the compliance.

Informations sur l'exposition aux radiations RF: Le produit est conforme aux règles de la FCC et d'ISDE (CNR-102) en ce qui concerne la limite d'exposition portable RF définie pour un environnement non contrôlé et est sans danger pour le fonctionnement prévu, tel que décrit dans ce manuel. Ce produit n'est pas soumis à l'évaluation de routine de l'exposition aux RF par la FCC conformément à la section 2.1093 et à la norme CNR-102 d'ISDE. Une réduction supplémentaire de l'exposition aux RF peut être obtenue si le produit peut être maintenu aussi loin que possible du corps de l'utilisateur ou si l'appareil est réglé sur une puissance de sortie inférieure, si cette fonction est disponible.

Cet émetteur ne doit pas être installé ou utilisé en conjonction avec une autre antenne ou un autre émetteur. L'utilisation d'autres accessoires non vérifiés par le fabricant ne peut pas garantir la conformité.

China RoHS

The device is marked with the China RoHS symbol, indicating compliance with regulations regarding hazardous substances.

Note on RoHS table symbols:

• 'o': Indicates that the content of this hazardous substance in all homogeneous materials of this part is below the limit requirement specified in GB/T 26572.
• 'x': Indicates that the content of this hazardous substance in at least one homogeneous material of this part exceeds the limit requirement specified in GB/T 26572.

The table is compiled according to SJ/T 11364.