DJI Phantom 3 4K Quick Start Guide

Introduction to the Phantom 3 4K

It's time to meet your Phantom 3 4K. The Phantom 3 4K's camera records video at up to 4K and captures 12 megapixel photos.

Review the diagram below for a full list of your Phantom 3 4K's parts:

Remote Controller

This powerful Remote Controller allows you to pilot and maneuver your Phantom 3 4K at distances over 3,940 feet (1.2 km)* away, while putting selected camera controls at your fingertips. Built into your Remote Controller is a rechargeable LiPo battery and Wi-Fi video link, which when paired with a compatible mobile device gives you a live HD view from the Phantom's camera.

Flight Controls (Mode 2)

The left stick controls the aircraft's altitude and heading, while the right stick controls its forward, backward, left and right movements. The gimbal dial controls the camera's tilt.

• Left Stick: Up (Ascend), Down (Descend), Left (Yaw left), Right (Yaw right).
• Right Stick: Up (Fly forward), Down (Fly backward), Left (Fly left), Right (Fly right).
• Gimbal Dial: Controls the camera's tilt up or down.

*Note: Transmission distance is measured in a wide open area with minimal magnetic interference, and at an altitude of about 400 feet (120 meters). FCC compliant mode at 3,940 feet (1.2 km) and CE compliant mode at 1640 feet (500 meters).

Using Phantom 3 4K

1. Download the DJI GO App

   Search 'DJI GO' on the App Store or Google Play and download the app to your mobile device. The DJI GO app supports iOS 8.0 and Android 4.1.2, or later versions.

2. Check Battery Levels

   Press once to check the battery level. Press twice and hold to turn on/off.

3. Charging the Batteries

   Remove the battery and connect it to the provided charger. Charge Time: ~1.5 hours. When charging is complete, the battery and the Status LED will automatically turn off.

Prepare for Takeoff

1. Preparing the Remote Controller

   Unfold the remote controller. Press the button on the side of the Mobile Device Holder to release the clamp. Place your mobile device into the clamp and adjust it so that the mobile device is held securely in place.

2. Prepare for Takeoff

   Follow these steps for takeoff preparation:

   • Remove the gimbal packing.
   • Remove the gimbal clamp on the camera.
   • Power on the remote controller and the aircraft.
   • On your mobile device, select 'Phantom3_XXXXXX' from the Wi-Fi networks and enter the default password '12341234'.
   • Activate your Phantom if you are using it for the first time. This requires an internet connection.
   • Launch the DJI GO app and tap Enter Camera View, then follow the on-screen instructions.
   • Tap the Aircraft Status Bar at the top of the screen and choose Calibrate. Follow the instructions to calibrate the aircraft's compass.

   Propeller Installation: Black propeller nuts go on motors with black dots. Silver propeller nuts go on motors without black dots.

   Safety Note: Tighten the propellers with both hands before each flight. ?

Flight

Safe to Fly (GPS)

Before taking off, ensure the Aircraft Status Bar in the DJI GO app indicates 'Safe to Fly (GPS)'.

In the DJI GO App:

• Auto Takeoff: The aircraft will take off and hover at an altitude of 4 feet (1.2 meters). ▶️
• Auto Landing: The aircraft will land vertically and stop its motors. ⬇️
• Return-To-Home: Brings the aircraft back to the Home Point. Tap again to stop the procedure. ?

Note: The aircraft will not avoid obstacles while it is returning to the Home Point. An appropriate RTH altitude MUST be set before flight. Use control sticks to guide the aircraft. Refer to the Safety Guidelines and Disclaimer for more details.

Manual Takeoff

Use the Combination Stick Command to start/stop the motors, or push the left stick up (slowly) to take off. ⬆️

Manual Landing

Push the left stick down (slowly) until you touch the ground. Hold a few seconds to stop the motors. ⬇️

Safety Note: Never stop the motors mid-flight, otherwise the aircraft will crash. Only stop the motors when the aircraft is on the ground or as required in emergency situations to reduce the risk of damage or injury. ❌

Fly Safe

DJI encourages you to enjoy flying in a safe, responsible and smart way.

• DO NOT FLY near or above people, near trees, power lines or buildings. ?
• DO MONITOR YOUR ALTITUDE and fly under 400 feet (120 meters). ?
• DO NOT FLY in rain, snow, fog, and wind speeds exceeding 22 mph or 10 m/s. ?
• DO MAINTAIN LINE OF SIGHT and avoid flying behind buildings or obstacles that block your view. ?

It is important to understand basic flight guidelines, for the safety of both you and those around you. Refer to the Safety Guidelines and Disclaimer for more information.

For information on No Fly Zones, visit: http://flysafe.dji.com/no-fly

Specifications

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Download the user manual in the DJI GO app for more information. This Quick Start Guide is subject to change without prior notice. ©2015 DJI. All Rights Reserved. Designed by DJI. Printed in China.