Lectron Electric Vehicle Charging — Lectron EV
User Manual for LECTRON models including: 15ATSLBLKUS 15 Amp Portable EV Charger Compatible, 15ATSLBLKUS, 15 Amp Portable EV Charger Compatible, Portable EV Charger Compatible, EV Charger Compatible, Charger Compatible, Compatible
User Manuals | Lectron â Lectron EV
File Info : application/pdf, 10 Pages, 6.75MB
DocumentDocument15 Amp Portable EV Charger Compatible with Tesla USER MANUAL Contents Safety Precautions .............................................................................................................. 2 In the Box ............................................................................................................................. 3 How to Install ....................................................................................................................... 4 LED Indicators ...................................................................................................................... 4 LED Status ............................................................................................................................ 5 Charging Your Vehicle ........................................................................................................ 5 Troubleshooting .................................................................................................................. 7 Specifications ....................................................................................................................... 8 Get More Support ................................................................................................................ 9 page 1 Safety Precautions · It is recommended that electrical outlets for your charger should be installed by a licensed and qualified electrician. To avoid serious injury or death, installation must comply with the provisions of the National Electric Code (NEC) and all local codes. If there are conflicts between local codes and the NEC, local codes shall take precedence. · This product must be grounded. In case of a malfunction or breakdown, grounding can help reduce the risk of electric shock. This product includes a cord that is equipped with a grounding conductor and a grounding plug. The plug must be inserted into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. · SHOCK HAZARD - Make sure the plug is fully inserted into the wall outlet to avoid any exposed metal surfaces. · Do not leave children unattended or unsupervised around chargers or other power outlets or devices. · DO NOT DROP THE CHARGER OR HANDLE. · If the output plug is separated from the charger module or the charging handle, DO NOT ATTEMPT TO REPAIR THE CABLE YOURSELF. For assistance, contact Customer Service at: contact@ev-lectron.com · When using your charger, basic precautions should always be followed, including: - Read warnings on the charger-cord label before operating the charger for the first time. - Read all instructions in this guide before using the charger. - Never use the charger with non-approved power adapters or other power components. page 2 In the Box 15 Amp portable EV charger LED status light Cable (16 ft) POWER CONNECT CHARGING ERROR Charging handle (Tesla) Compatibility NEMA 5-15 (120 V) Tesla Plug page 3 How to Install LED Indicators 1. Install the bracket with the screw then attach the charger module to the mounting bracket until it clicks. POWER CONNECT CHARGING ERROR Power status On/Off Charger-connection status Charging status Error indicator POWER CONNECT CHARGING ERROR page 4 LED Status Function Status LED displays Normal status light Powered, not connected Connected, not charging Charging Charging complete Communication error Surge-voltage protection Low-voltage protection Surge-current protection Leakage protection High-temperature protection Current fault / short circuit Ground fault Power (red) LED Status Connect Charging Error (blue) (green) (yellow) On - Flashing - Off - Charging Your Vehicle NOTE: Ensure your car is parked and the engine is turned OFF. 1. Insert the charger into an appropriate wall outlet. NEMA 5-15 (120 V) 2. The Power and Connected lights will light up and stay solid, which means the charger is receiving AC power and is ready for use. POWER CONNECT CHARGING ERROR page 5 3. Plug the charging handle into your vehicle's charging outlet. 4. Charging begins automatically. Power will be delivered in accordance to the demand of your vehicle. While charging, the Charging Indicator will continuously blink. Always verify your vehicle-charging status by checking the vehicle panel. POWER CONNECT CHARGING ERROR 5. When your vehicle is fully charged, the Charging Indicator light will stay solid. Your vehicle has a "dashboard gauge", which also shows if your vehicle is fully charged. Refer to your vehicle user manual to find the location of the gauge on the dashboard. 6. When the vehicle is fully charged, pull the charging handle out from the vehicle. POWER CONNECT CHARGING ERROR NOTE: The charger requires a 120 V AC split phase. It draws a maximum of 15 Amps of continuous current. page 6 Troubleshooting Please refer to this troubleshooting guide to fix common charging errors or while using the portable charger. Problem Possible Cause Solution Charging Indicator does not illuminate Vehicle will not charge No power to the charger. 1. Check the circuit breaker and other circuit loads. 2. Try another wall outlet. 3. Ensure that the charger module (and adapter if operating in 120 V AC mode) is fully inserted into the wall outlet. Charging handle is not properly inserted into the vehicle. Vehicle cannot accept any charge. Communication error between the charger and vehicle. Contact Lectron Customer Support at contact@ev-lectron.com for assistance. 1. Inspect the charging handle. 2. Remove the charging handle from the vehicle, then reinsert it into the vehicle outlet until it clicks. Verify that the vehicle charge timer is set to permit charging. Refer to the vehicle user manual for charge timer instructions. Contact Lectron Customer Support at contact@ev-lectron.com for assistance. Above the temperature limit. Cases: 1. Temperature is too high. The charger will restart charging when it cools down. 2. House/socket wiring may be faulty. 1. Inspect the charger module for overheating: a. Carefully unplug the charger module from the wall outlet and allow it to cool. b. If the problem continues, contact Lectron Customer Support at contact@ev-lectron.com for assistance. 2. Disconnect the charger from the wall outlet. 3. Have a qualified electrician inspect the wall outlet and adapter. Error Indicator is blinking rapidly Utility fault. 1. Disconnect the charger module from the wall outlet and reconnect it. 2. If the problem continues, have a qualified electrician inspect the ground circuit of the wall outlet. page 7 APPROVED · IP65 TESTED & APPROVED · IP65 TESTED & Specifications Rated current: Input/output: Frequency: Cable length: Plug: EV charging handle: Dimensions: Weight: Operating temperature: Material: Control-box water resistance: Charging handle water resistance: Reference standard: 15 Amp 120 V AC 50/60 Hz 16 ft (5 m) NEMA 5-15 Tesla (Compatible with NACS) 8.1 x 3.2 x 1.6 in (20.8 x 8.2 x 4.23 cm) 5.3 lb (2.4 kg) -22 °F to +122 °F (-30 °C to +50 °C) PC+ABS IP65 Type 3R UL2594, UL2251, UL2231 APPROVED · IP65 TESTED & APPROVED · IP65 TESTED & page 8 Get More Support Scan the QR code below or email us at contact@ev-lectron.com www.ev-lectron.com Made in China