Honeywell - The Future Is What We Make It
Installation Guide for Honeywell models including: 205820A Foot Mount Bracket
This document provides installation instructions for the. 205820A Foot-Mount Bracket for three-point mounting of a. Direct Coupled Actuator (DCA).
File Info : application/pdf, 2 Pages, 207.16KB
DocumentDocumentThis is a legacy product document supported by Resideo. It is no longer manufactured 205820A Foot-Mount Bracket FOR DIRECT COUPLED ACTUATORS APPLICATION This document provides installation instructions for the 205820A Foot-Mount Bracket for three-point mounting of a Direct Coupled Actuator (DCA). SPECIFICATIONS Parts Included: Bracket (1). Hexagonal Standoffs (3). Screws (3). Lockwashers (3). INSTALLATION INSTRUCTIONS High-Torque Mounting 1. Using any two of the five mounting holes, mount the bracket to the mounting surface. 2. Attach the DCA to the bracket with three 1/4 in. screws and lockwashers. See Fig. 3. 3. Remove the actuator output hub, if desired. See the instructions provided with the actuator. 4. Perform wiring and operating procedures for the actuator. See the instructions provided with the actuator. INSTALLATION When Installing this Product... 1. Read these instructions carefully. Failure to follow them could damage the product or cause a hazardous condition. 2. Check the ratings given in the instructions and on the product to make sure the product is suitable for your application. 3. Installer must be a trained, experienced service technician. 4. After installation is complete, check out product operation as provided in these instructions. Mounting Mounting varies slightly for some DCA models. High-torque (150 lb-in. and 300 lb-in.) DCA do not require standoffs. Standard Mounting 1. Using three 1/4 in. (6 mm) screws and lockwashers, attach the 1/2 in. (13 mm) hexagonal standoffs to the bracket. See Fig. 1. 2. Using any two of the five mounting holes, mount the bracket to the mounting surface. 3. Attach the DCA to the open end of the hexagonal standoffs with three 1/4 in. screws and lockwashers. See Fig. 2. 4. Remove the actuator output hub, if desired. See the instructions provided with the actuator. 5. Perform wiring and operating procedures for the actuator. See the instructions provided with the actuator. HEXAGONAL STANDOFFS SCREW MOUNTING HOLES (5) BRACKET LOCKWASHER M11491A Fig. 1. 205820A Foot-Mount Bracket. ® U.S. Registered Trademark Copyright © 1999 Honeywell Inc. · All Rights Reserved 63-2500-2 205820A FOOT-MOUNT BRACKET STANDOFF BRACKET BRACKET 12 90 60 30 60 30 12 0 RDEIRVEECRTSE ACTUATOR LOCKWASHER SCREW M11490A Fig. 2. Mounting the DCA on bracket using standoffs. ACTUATOR LOCKWASHER SCREW M13309 Fig. 3. Mounting a high torque DCA on bracket. By using this Honeywell literature, you agree that Honeywell will have no liability for any damages arising out of your use or modification to, the literature. You will defend and indemnify Honeywell, its affiliates and subsidiaries, from and against any liability, cost, or damages, including attorneys' fees, arising out of, or resulting from, any modification to the literature by you. Automation and Control Solutions Honeywell International Inc. Honeywell Limited--Honeywell Limitée 1985 Douglas Drive North 35 Dynamic Drive Golden Valley, MN 55422 Scarborough, Ontario M1V 4Z9 63-2500--2 B.B. Rev. 5-99 2 www.honeywell.com