Instruction Manual for MOSITOECO models including: 2AU7R-MST-F304B, 2AU7RMSTF304B, mst f304b, MST-F304B Remote Control, MST-F304B, Remote Control
Huizhou MOSITOECO intelligence Lighting Technology Co., Ltd MST-F304B Remote control 2AU7R-MST-F304B 2AU7RMSTF304B mst f304b
MST-F304B Remote control operation instruction As shown in the figure: 1 button: Press this key to turn on or off the fan 21 -3Number button: Gear 1-3 is the fan/motor speed button, gear 1 is the lowest speed, gear 3 is the highest speed 3 Night lamp button: Press this key for the night light mode, and the lamp power is directly reduced to the minimum 4 anti-theft model button: Press this key for anti-theft mode, turn off the fan, turn on the light, and turn on the light for 5 minutes every 2 hours 5 Natural wind button: Press this key for natural wind, and the fan rotates from the current gear to the first gear 6CCT button: Short press this key to change the color temperature from 2700/3000/4500/5700/6500K, long press this key to change the color temperature from 6500->2700K or 2700K->6500K 7 LED ON/OFF button: Press this key to turn the light on and off 8DIM button: Long press this key to adjust the brightness, long press the brightness downward or upward adjustment, until adjusted to the highest or lowest brightness, to the target brightness release will stop adjusting the brightness 91H2H4HIs the timed shutdown key, press this key, 1H/2H/4H later turn off the motor 10Blue lightPress any key of the remote control, the indicator light will light up, and the remote control will issue instructions Restore electrical power.Within 30 seconds of restoring electrical power, press and hold the " "button on the remote controtransmitterfor 5seconds or until ight on the fan blinkstwiceUsethe remote control transmitter to test the liaht and fan functions to confirm the learning process is complete. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment The devices has been evaluated to meet general RF exposure requirement the device can be used in portable exposure condition without restrictionWPS 文字