Shoulder Banshee Instruction Sheet

R/C Mode

This section details the remote control (R/C) functions for the Shoulder Banshee.

Remote and Banshee Overview

Remote: Features buttons for head movement and wing control.

Banshee: The toy itself, with various interactive points.

Shoulder Pad Placement

Clip the shoulder pad to secure the tail of the Shoulder Banshee onto your shirt. Place the shoulder connector underneath your shirt on either the left or right shoulder. Sit the Banshee on the shoulder pad to secure the magnetic connection.

Pairing Instructions

1. Slide the remote switch to "ON". The LED on the front of the remote will blink slowly.
2. Slide the Banshee switch to "ON". The LED on the bottom of the Banshee will blink slowly.
3. The LED on the front of the remote and the bottom of the Banshee will turn off to indicate successful pairing.

Default Position

The Banshee's default position is with its neck centered, mouth closed, and wings down.

Mouth Control

Press the button to activate mouth movement and sounds.

Head Movement

• Left: Press the left button to turn the head left. If there is no action after 5 seconds, the neck will default back to center.
• Right: Press the right button to turn the head right. If there is no action after 5 seconds, the neck will default back to center.

Wings Control

Press the wing button to activate wing flapping (wings go up then back down once). Hold down the button for continuous wing movement (up and down, up and down, etc.). When the button is released, the wings will return to the default position.

Idle Shutoff: The remote will turn off after 5 minutes of no interaction. Slide the switch "OFF" and "ON" to reactivate.

Idle Shutoff (Banshee): The Banshee will turn off after 10 minutes of no interaction. Slide the switch "OFF" and "ON" to reactivate.

Interactive Mode

Touch sensors on the chest and back will activate random movements and sounds. If the Banshee is left idle, randomized movements and sounds will be activated.

Connectivity Mode

Press the connectivity button to talk to nearby Banshees and Baby Banshees.

Warnings and Battery Information

WARNING: CHOKING HAZARD - Small parts. Not for children under 3 years. (Baby Banshee sold separately)

Battery Requirements:

• Remote requires 2 AAA 1.5V batteries (included).
• Banshee requires 3 AA 1.5V batteries (included).

Battery Instructions:

• DO NOT MIX OLD AND NEW BATTERIES.
• DO NOT MIX ALKALINE, STANDARD (CARBON ZINC), OR RECHARGEABLE (NICKEL-CADMIUM) BATTERIES.
• NON-RECHARGEABLE BATTERIES ARE NOT TO BE RECHARGED.
• THE SUPPLY TERMINALS ARE NOT TO BE SHORT-CIRCUITED.
• DO NOT USE RECHARGEABLE BATTERIES.
• REMOVE BATTERIES WHEN NOT IN USE OR DISCHARGED.

Battery Replacement:

1. Remove the screw to access the battery compartment.
2. Open the battery compartment. Exhausted batteries are to be removed.
3. New batteries are to be inserted with the correct polarity.
4. Replace the battery door and secure with the screw.

FCC Compliance Information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.

Regulatory Information

Disney hereby declares that this R/C car is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.