Instruction Manual for CTA models including: LT-SAM, Laptop Security Arm with VESA Mounting Base
CTA Digital Laptop Security Arm with Vesa Mounting Base LT-SAM
CTA Digital - notebook arm mount - with VESA mounting base VESA 100 x 100 mm, VESA 75 x 75 mm, theft protection Manufacturer Warranty 1-year warranty What's in the Box1) Security holder & Mount Plate1) Clamp Mount w/ VESA Plate2) Keys1) Set of mounting hardwarePDF: Click Here
For Laptop LT-SAM Laptop Security Arm with VESA Mounting Base Package Contents: Keys Nut Screws for VESA Allen Key Instructions: 1. Installing Clamp Mount When installing on a Flat Surface: When installing on a Pole: Allen Key (Smaller) 2.Connecting the Holder to the Laptop Plate Base Take the laptop holder and align the holes on the bottom of the middle joint to the holes on laptop plate as shown. Using the provided tool, screw in the screws from below into the bottom of the laptop holder joint until securely tightened. 4. Installing your Laptop to the Holder Plate Base Key 3.Connecting the Laptop Holder Plate Base to the VESA Joint Align the VESA holes of the laptop plate with the VESA mount as shown. Using the provided tool, screw the (4) screws from above the plate through both the plate and VESA mount while holding the (4) hex nuts from behind with your hand. Keep screwing until tight and secure. Unlock the holder with the key, and pull out the lock component to allow the holder to adjust. Extend/Retract the holder to fit the laptop as shown. 5. Adjusting Joints Once the laptop holder is secure, push the lock component back in, and rotate and lock the holder on the back. Allen Key Turn the knob countercockwise to loosen any of the joints on the vehicle mount. Adjust the arm to the deesired angle and position, then rotate clockwise to tighten and secure the position Adjust and rotate middle joint to orient your laptop as needed as shown The connection of the higle of the holder allows you to adjust your Laptop screen angle. Using the provided allen key, you can loosen and tighten the coonection as needed. 1. Place rubber grip flat insert into the clamp groove. Rotate to loosen handle counter-clockwise to widen around surface ledge. Rotate clockwise to tighten until secure. 2. Remove rubber grip flat insert from clamp groove. Rotate to loosen handle counter-clockwise to widen around surface ledge. Rotate clockwise to tighten until secure.Adobe PDF library 15.00 Adobe Illustrator 24.3 (Macintosh)