High-Quality Custom Window Coverings | Sun Glow
Installation Guide for SUN GLOW models including: V84 STANDARD, V102 STANDARD, V84 FLEX, Curved Cassette, Compact Curved Cassette, Roller Shade System, Curved Cassette and Compact Curved Cassette Roller Shade System
Installation Instructions | Vision | 2022-04-29 www.mysunglow.com 2 of 2 3 INSTALL VISION TM ROLLER SHADE SYSTEM With the Front Fascia facing you, insert the front edge of the Assembly Bracket onto the front lip of each Flex Mounting Bracket,
File Info : application/pdf, 2 Pages, 388.05KB
DocumentDocumentRoller Shade - Curved Cassette & Compact Curved Cassette Installation Instructions WARNING STRANGULATION HAZARD -- Young children can be strangled by cords. Immediately remove this product if a cord longer than 22 cm or a loop exceeding 44 cm around becomes accessible. MISE EN GARDE RISQUE D'ÉTRANGLEMENT -- Les enfants en bas âge peuvent s'étrangler avec des cordes. Enlevez immédiatement ce produit si une corde mesurant plus de 22 cm devient accessible ou si le contour d'une boucle de plus de 44 cm devient accessible. 1 BRACKET POSITION Fully assembled & tested: Taking any VisionTM roller shade apart for any reason will void the warranty. V84 Standard MIN Distance = ¹/4" MAX Distance = 1¹/4" V102 Standard MIN Distance = ¹/4" MAX Distance = 1" V84 Flex MIN Distance = ¹/4" MAX Distance = 1" · Each VisionTM Roller Shade System comes standard with two mounting brackets. · It is important that the brackets be securely mounted, level, and aligned to each other. Shimming may be required. 2 INSTALL MOUNTING BRACKETS Attach Flex Mounting Brackets using two #8x1.5" Pan Head Zinc Screws included or equivalent, depending on the surface type. Ensure all screws should be securely fastened to a sturdy structure. For outside wall mounted applications, a spacer plate might be required. Ceiling Mount V84 STANDARD & V102 STANDARD Wall Mount Lateral Mount Screw Head Zone Ceiling Mount V84 FLEX Wall Mount Installation Instructions | Vision | 2022-04-29 www.mysunglow.com 1 of 2 3 INSTALL VISIONTM ROLLER SHADE SYSTEM With the Front Fascia facing you, insert the front edge of the Assembly Bracket onto the front lip of each Flex Mounting Bracket, push upward and back until the back edge of the Assembly Bracket snaps into the bottom tab of the Flex Mounting Bracket. Repeat this process for each bracket. V84 FLEX Open Position Back Front V84 FLEX Open Position Front Edge Closed Position Snap Closed Position 4 LEVELING THE SHADE Direction Adjustment Screw: Insert #0 Robertson or Small Flat Head To adjust shade level if window is not square, follow the steps below. Turn the small Adjustment Screw on the Adjustable End Bracket either clockwise to raise the shade or counter clockwise to lower the shade until the shade is level. 5 INSTALL THE SAFETY SHIELD NOTE: For shades with chain operation only. Ensure that Safety Shield is carefully and properly installed. Installation Instructions | Vision | 2022-04-29 www.mysunglow.com 2 of 2