User Guide for HYPERX models including: HX433C16PB3K2 32 RAM Memory, HX433C16PB3K2 32, RAM Memory

HX433C16PB3K2 32.ai

kfujiwar

Manual HX433C16PB3K2 32

HyperX Predator, DDR4, 32 GB (2 x 16 GB), 3333 MHz (HX433C16PB3K2/32) ▻ Оперативная память RAM, Комплект, Для ПК, DDR4, 32 GB (2 x 16 GB), 3333 MHz, DIMM ▻ купить в GEEK.MD


File Info : application/pdf, 2 Pages, 152.29KB

PDF preview unavailable. Download the PDF instead.

Manual HX433C16PB3K2 32
Memory Module Specifications
HX433C16PB3K2/32
32GB (16GB 2G x 64-Bit x 2 pcs.) DDR4-3333 CL16 288-Pin DIMM Kit
DESCRIPTION
HyperX HX433C16PB3K2/32 is a kit of two 2G x 64-bit (16GB) DDR4-3333 CL16 SDRAM (Synchronous DRAM) 2Rx8, memory module, based on sixteen 1G x 8-bit FBGA components per module. Each module kit supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0. Total kit capacity is 32GB. Each module has been tested to run at DDR4-3333 at a low latency timing of 16-18-18 at 1.35V. The SPDs are programmed to JEDEC standard latency DDR4-2400 timing of 17-17-17 at 1.2V. Each 288-pin DIMM uses gold contact fingers. The JEDEC standard electrical and mechanical specifications are as follows:
XMP TIMING PARAMETERS ·JEDEC: DDR4-2400 CL17-17-17 @1.2V ·XMP Profile #1: DDR4-3333 CL16-18-18 @1.35V ·XMP Profile #2: DDR4-3000 CL15-17-17 @1.35V

SPECIFICATIONS

CL(IDD) Row Cycle Time (tRCmin) Refresh to Active/Refresh Command Time (tRFCmin) Row Active Time (tRASmin) Maximum Operating Power UL Rating Operating Temperature Storage Temperature

17 cycles 45.75ns(min.) 350ns(min.)
32ns(min.) TBD W* 94 V - 0 0o C to +85o C -55o C to +100o C

*Power will vary depending on the SDRAM used.

FEATURES
· Power Supply: VDD = 1.2V Typical · VDDQ = 1.2V Typical · VPP = 2.5V Typical · VDDSPD = 2.2V to 3.6V · On-Die termination (ODT) · 16 internal banks; 4 groups of 4 banks each · Bi-Directional Differential Data Strobe · 8 bit pre-fetch · Burst Length (BL) switch on-the-fly BL8 or BC4(Burst Chop) · Height 1.661" (42.20mm)

hyperxgaming.com

Continued >> Document No. 4808708A 07/13/18 Page 1

ccoonnttiinnuueedd
MODULE WITH HEAT SPREADER 8.3

MODULE DIMENSIONS

133.35

HyperX
42.2

All measurements are in millimeters.
(Tolerances on all dimensions are ±0.12 unless otherwise specified)
133.35 129.55
2.10±0.15

31.25

3.00

14.60 17.60 8.00
11.00

2.70±0.15

Detail A Pin 1

Detail B

Pin 35

Pin 47

Detail D

Detail E

Detail C

Pin 105

Pin 117

3.35 28.90

64.60

56.10

22.95

The product images shown are for illustration purposes only and may not be an exact representation of the product. Kingston reserves the right to change any information at anytime without notice.

FOR MORE INFORMATION, GO TO WWW.HYPERXGAMING.COM

All Kingston products are tested to meet our published specifications. Some motherboards or system configurations may not operate at the published HyperX memory speeds and timing settings. Kingston does not recommend that any user attempt to run their computers faster than the published speed. Overclocking or modifying your system timing may result in damage to computer components.

HyperX is a division of Kingston. ©2018 Kingston Technology Corporation, 17600 Newhope Street, Fountain Valley, CA 92708 USA. All rights reserved. All trademarks and registered trademarks are the property of their respective owners.

Document No. 4808708A Page 2 hyperxgaming.com



References

PScript5.dll Version 5.2.2 iLovePDF