WinBridge S100 Pro Portable PA System

Package Includes:

• 1 * S100 Pro Speaker
• 2 * Handheld Microphones
• 1 * AUX Cable
• 1 * Type-C Charging Cable
• 1 * Manual

After-sale Service

WinBridge provides a one-year warranty and lifetime technical support.

Toll Free Hotline: +1 (833) 996-2881

Email: info@wwinbridge.com

Website: www.winbridgestore.com

If you encounter any difficulties, please contact WinBridge support via email.

Notes and Warnings

FCC Compliance:

This equipment complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment generates, uses, and can radiate radio frequency energy. If not installed and used according to instructions, it may cause harmful interference to radio communications. There is no guarantee that interference will not occur in a particular installation. If interference occurs, try to correct it by:

• Reorienting or relocating the receiving antenna.
• Increasing the separation between the equipment and receiver.
• Connecting the equipment to an outlet on a different circuit from the receiver.
• Consulting the dealer or an experienced radio/TV technician.

The device has been evaluated to meet general RF exposure requirements and can be used in portable exposure conditions without restriction.

FCC Warning: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Troubleshooting - Wireless Microphone Interference:

Q: Why does the wireless microphone cut in and out during use?

A: This is likely due to interference on the current frequency. Briefly press the "Power Key" on the handheld microphone 3-4 times to switch to another frequency and resolve the issue.

Feedback or Howling:

• Avoid pointing the handheld microphone directly at the speaker.
• In smaller spaces, reduce the volume to prevent feedback or howling.

Frequently Asked Questions:

Q: The switch is on, but there is no sound.

A1: If the screen light is off, the power is low. Charge the device.

A2: If the volume is at minimum, adjust it to an appropriate level.

A3: Check if the mute button has been pressed. Press it again to resume sound.

Q: The microphone is paired, but there is no sound output.

A: Ensure the MIC.VOL on the speaker is turned up. Rotate it clockwise.

Q: The battery indicator shows only one bar after several hours of charging.

A: Use a charger with an output of 5V-3A. Chargers with lower output charge the device slowly.

Q: What should be paid attention to when switching sound effects?

A: For Professional, Pop, and Hip-Hop modes, turn on the echo knob to enhance the effect. In Acoustic mode, the echo is automatically turned off.

S100 Pro Function Illustration

Controls:

• INSTRUMENT VOLUME: Controls instrument volume. Rotate clockwise to increase, counterclockwise to decrease.
• ECHO.VOL: Controls reverb volume. Rotate clockwise to increase, counterclockwise to decrease.
• MIC.VOL: Controls microphone volume. Rotate clockwise to increase, counterclockwise to decrease.
• MON.VOL: Controls monitor volume. Rotate clockwise to increase, counterclockwise to decrease.
• VOLUME: Master Volume control.

Modes:

The S100 Pro offers four sound modes: Acoustic, Professional, Pop, and Hip-Hop. In Acoustic mode, Echo is turned off. To switch modes, press the Mic icon on the speaker or the handheld microphone. Use the Echo button to adjust reverb intensity.

Ports and Interfaces:

• LED Screen
• Type-C charging interface
• USB Port: Connect a USB flash drive to play audio files.
• TF Card Slot: Insert a TF card to play audio files.
• LIVE Stream Port: Connect your device for enhanced audio during broadcasts (cable not included).
• Headphone Jack: Plug in headphones for real-time audio monitoring.
• AUX Jack: Connect external audio devices via AUX cable.
• 6.35mm Microphone Jack: Connect wired microphones.
• Instrument Input: Connect musical instruments like guitars.

Handheld Microphone:

• Power Button: Long press to turn on/off.
• Charging Light: Steady red while charging, turns off when fully charged.
• Volume Up Key (+): Long press to increase volume.
• Volume Down Key (-): Long press to decrease volume.
• Microphone Mode Key (M): Short press to switch modes (Acoustic, Professional, Pop, Hip-Hop).
• Switch Key: Long press to turn on/off.
• Mute Button: Short press to mute/unmute audio.
• Playback Controls: Short press for previous/next track, pause/play. Long press for fast rewind/forward.
• Loop Button: Short press to switch between single loop and all loop.

Connectivity and Pairing:

Microphone and Speaker Auto Pairing:

The microphone and speaker automatically pair when powered on.

Manually Pairing Handheld and Speaker:

1. Turn on the speaker. Short press the 'M' key to switch to UHF mode (voice prompt: "UHF Mode").
2. Long press the 'M' key for about 3 seconds until "UHF" flashes on the display (voice prompt: "UHF is waiting for pairing").
3. Turn on the handheld microphone. Simultaneously press the "+" and "-" buttons until "UHF" stops flashing and you hear "UHF paired".
4. Pairing is successful. Repeat for the other microphone.

Bluetooth Pairing:

1. Short press the 'M' key on the speaker to switch to Bluetooth mode (display flashes "BLUE", voice prompt: "Bluetooth Mode").
2. On your Bluetooth device, search for "S100 Pro" and pair. The "BLUE" display will stop flashing, and you will hear "Bluetooth paired".

Note: In Bluetooth mode, short pressing the speaker's 'M' key disconnects Bluetooth. To use the wireless microphone and Bluetooth audio simultaneously, connect the microphone first, then the Bluetooth device.

Playback Controls (USB/TF Card):

• Previous Track: Short press. Long press does not support fast rewind.
• Next Track: Short press. Long press does not support fast forward.
• Pause/Play: Short press.
• Loop: Short press to switch between single loop and all loop.

Speaker Charging Status:

Charging takes approximately 5 hours with a 5V/3A charger. Battery indicator lights flash while charging and stop flashing when fully charged.

Handheld Microphone Charging Status:

Charging takes approximately 2 hours with a 5V/2A charger. The red charging light remains steady and turns off when fully charged.

Specifications:

• Output Power: 70W
• Frequency Range: 60Hz-18KHz
• Battery Capacity: 4500mAh
• Speaker Usage Time: 4-5 hours
• Charging Voltage: 5V/3A
• Handheld Mic Usage Time: 10+ hours