Walkie-Talkies

Function Explanation

Warning: Contains small parts, may pose a choking hazard. Not suitable for children under 3 years of age.

Description of components:

• Antenna: (天线/Antenna/antenne/antena/Antenne/antenna)
• Talk Button: (对话按钮/Talk Button/Bouton Parler/botón hablar/Sprechtaste/Pulsante parla)
• Switch/changer: (开关/Switch/changer/cambiar/schalten/interruttore)
• Handset and Microphone: (听筒和麦克风/Handset and Microphone/Combiné et microphone/Auricular y micrófono/Hörer und Mikrofon/Ricevitore e microfono)

[Image: Two toy walkie-talkies, one red and one green, each featuring cartoon animal characters (a rabbit on the red one, a fox on the green one) and branding.]

Method of Use

Power on/off

• Please install 3 AA batteries in the back battery compartment for the first time.
• Push the on key upward; the indicator light is on, indicating normal boot.
• Push the on key downward; the indicator light is off, indicating normal shutdown.

Speech signal sending / receiving

• Long press the right call button to send the speech signal.
• Release the right call button to pick up the speech signal.
• When sending speech signals, speak at a normal volume, approximately 5-10cm away from the microphone. Speaking too loudly may distort the voice.
• When transmitting or receiving signals, keep the walkie-talkie in a vertical position, holding the middle and lower parts of the product. Avoid getting too close to the antenna to ensure optimal call distance.

Installation of batteries

• This product uses 3 x 1.5V (AA) batteries individually. A pair of walkie-talkies requires a total of 6 batteries and needs to be assembled by adults.
• Loosen the battery cover screws with a screwdriver and uncover the battery cover.
• Insert the batteries according to the correct polarity.
• Close the battery cover and tighten the battery cover screws with a screwdriver.

[Image: Diagrams showing the battery compartment of a walkie-talkie, illustrating the location of screws, the battery cover, and where to insert AA batteries.]

Safety Instructions

For your safe and efficient use, please read the following safety information.

Safety of batteries

• Non-rechargeable batteries cannot be recharged.
• Rechargeable batteries should only be charged under adult supervision.
• Rechargeable batteries should be removed from the toy before charging.
• Different types of batteries or old and new batteries should not be mixed.
• Batteries should be inserted with the correct polarity.
• Batteries should be removed from toys when not in use.
• The power terminals must not be short-circuited.

User security information

• Please turn off the intercom before entering flammable and explosive environments. Do not replace or charge the battery in such environments.
• Do not use a walkie-talkie with a damaged antenna, as it may cause minor burns if exposed to the skin.
• Maintenance of the walkie-talkie should only be carried out by professional technicians; do not disassemble it yourself.
• To avoid issues caused by electromagnetic interference or compatibility, turn off the walkie-talkie in places with a "Please turn off the intercom" sign.
• This walkie-talkie is not fully waterproof; please keep it dry. Do not expose it to direct sunlight for extended periods or place it near a heating device.
• When transmitting, keep the intercom in an upright position and speak close to the speaker.
• If wearing the walkie-talkie on your body, ensure the antenna is at least 5 cm away from the body during transmission.

Maintenance and Precautions

• Please wipe the surface with a clean and soft cloth.
• When using the product, handle it with care to avoid falling, collision, or strong impact, which could damage the product.
• The product contains electronic components. Avoid exposing it to water, electric shock, or strong magnetic fields, as these can cause product function failure.
• Please recycle properly, as discarding can impact the environment.
• Keep away from open flame or high-temperature places.
• Do not boil, use in disinfection cabinets, or place in a microwave for disinfection.

Product Parameters

Product name: Walkie talkies

Model: R-851

Frontal voltage: DC3V

Frontal static current: 50 mA

Frontal Fixed Power: 0.1 W

RF output power: < 10 mW

Frequency: 433 MHZ

Age: 3 years and up

FAQ

Q: Intercom not working? One can not receive?

A: Please ensure that the battery of the walkie-talkie is sufficient. Low or insufficient batteries can cause unclear communication or make it impossible to talk.

Q: Not clear, interference?

A: Please ensure the battery is sufficient. Avoid environments with radio wave interference, such as elevators and iron houses.

Q: Can I talk to more?

A: Yes, the same walkie-talkie model supports multiple intercoms.

Q: How far is the distance supported?

A: Up to 500 m (depending on environment).

After-sale Service

Warranty Terms

• Thank you for your support. Use the warranty card to enjoy the warranty service. Users should keep their purchase instructions and warranty card safe for replacement certificates.
• From the date of purchase, under normal circumstances, the commitment warranty period is one year for use failure.
• The following are not covered by the warranty:
  1. Damage caused by improper personal use or unreasonable maintenance.
  2. Damage caused by human factors such as unauthorized disassembly and modification of the product.
  3. Use of non-company parts.
  4. Normal wear and tear of the product.
  5. Damage caused by force majeure.
• In addition to the warranty, paid maintenance services are available. When applying for warranty, please send the product along with proof of purchase documents.
• For any questions about after-sales service, please consult the dealer or official customer service.

FCC Warning

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Important: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.