Liebherr RW2x2 Wine Cooler Installation Guide

Important Safety Information

Warning: Always follow safety precautions. The installation requires careful handling of the appliance.

Symbols:

• ? - Information
• PPE - Personal Protective Equipment (e.g., gloves)

Parts and Tools

Ensure all parts are present before beginning installation. The following parts and tools are typically required:

Included Parts:

• Various brackets and mounting hardware
• Screws (e.g., 2x 4x29 T15, 2x 5x7 T15, 2x 6x24 T15, 5x 4x19 T15, 4x M4x14 T15, 3x M4x14 T15)
• Mounting rails

Required Tools:

• Screwdriver (Torx T15)
• Wrench (SW19)
• Measuring tape
• Scissors

Installation Steps

Step 1: Preparation

Unpack the appliance and all accessories. Check for any damage. Ensure you have adequate space for installation, adhering to the specified dimensions (e.g., minimum clearance of 200 cm² at the rear).

Step 2: Mounting Brackets

Attach the mounting brackets to the appliance and the installation site according to the diagrams. Pay close attention to the orientation and placement of each bracket.

Step 3: Positioning the Appliance

Carefully position the wine cooler into its designated space. Ensure it is level and stable.

Step 4: Securing the Appliance

Use the provided screws to secure the appliance in place. The diagrams illustrate the correct screw types and locations.

Step 5: Door Installation/Adjustment

Follow the specific instructions for attaching or adjusting the appliance door. This may involve mounting hinges and ensuring the door opens and closes smoothly. Specific measurements for door alignment are provided (e.g., 42 mm adjustment).

Step 6: Final Checks

Verify all connections are secure and the appliance is stable. Ensure the door seals correctly. The maximum weight for attached panels should not exceed 20 kg.

Dimensional Information

Refer to the provided tables for specific dimensions (A, B, C, D, E, F, G, H) for different models (RW 222, RW 282). These dimensions are crucial for proper fitting and clearance.

Panel Mounting Details

Specific instructions are given for mounting panels, including the use of screws and alignment guides. Ensure panels are attached within the specified thickness limits (e.g., 16-22 mm for panel C).

Note: Throughout the installation process, refer to the detailed diagrams for precise guidance on component placement and screw usage.

Troubleshooting and Additional Information

The document includes diagrams that may require interpretation for specific installation scenarios. Blank pages are provided for notes.