LETO 3

Mounting and Ceiling Specifications

Mounting Surface: The mounting surface must be strong enough to hold at least 0.88lb (0.4kg).

Ceiling Thickness: The ceiling thickness must be between 1/4" & 1" (6mm & 25mm). If the ceiling thickness is thinner than 1/4" (6mm), use an #6-32 screw to secure the fixture.

Important Safety Instructions

English:

• This product is suitable for DRY INDOOR LOCATIONS ONLY.
• Ensure this product is NOT on the same circuit as inductive loads (e.g., fluorescent bulbs, discharge bulbs, ventilation fans, etc.).
• Allow air to flow freely around the fixture.
• Do not switch on line voltage until all wiring is complete.
• Incorrect wiring will result in irreparable damage to the LED and power supply.
• This product should only be installed by a licensed electrician.

French:

• Ce produit convient pour une installation DANS UN ENDROIT SEC SEULEMENT.
• Assurez-vous que des charges inductives ne se retrouvent pas sur le même circuit que ce produit (i.e., fluorescent, ampoules à décharge, ventilateurs, etc.).
• Permettez à l'air de circuler librement autour du luminaire.
• Complétez les branchements avant de mettre sous tension.
• Un branchement incorrect créerait des dommages irréparables à l'alimentation et au DEL.
• Ce produit devrait être uniquement installé par un électricien qualifié.

Warranty

English:

• This product must be installed in accordance with all applicable installation codes and ordinances.
• Limited five (5) years warranty.
• Warranty is void in the eventuality of unauthorized modifications and/or improper use.

French:

• Ce produit doit être installé conformément au code d'installation et autres normes applicables.
• Garantie limitée de cinq (5) ans.
• La garantie est non valide advenant une modification non autorisée ou un usage non approprié.

Choose Installation Type

Housing Installation

Standard:

Step 1: Install appropriate housing between ceiling joists. Connect the driver to the line voltage and ground to the enclosure.

Step 2: Finish ceiling installation. Make sure the hole is cut to the appropriate size and location.

Retrofit & Non Fixed Driver Installation:

Step 1: Ensure wire reaches fixture location.

Step 2: Finish ceiling installation. Make sure the hole is cut to the appropriate size and location.

Step 3: Connect the driver to the line voltage and ground to the enclosure. Push the driver into the ceiling.

Final Installation Steps

Step 1: Ensure power is off. Lower the quick connect wire from the ceiling and connect to the fixture until you hear a click. [audio-click-symbol]

Step 2: Compress the 3 springs inward until they clear the hole in the ceiling.

Step 3: Rotate the fixture to the desired orientation. Push it into the hole until the springs release and the fixture is flush with the ceiling.

Template Information

Note: Do not scale this when printing this template. ❗

Cutout size: 4.5" [115mm]