Product Manuals by Type | Applied Motion
User Guide for Logicbus models including: BD BD5 10 Brushless DC Motor Driver, BD BD5, BD BD10 Brushless DC Motor Driver, BD5, BD10, Brushless DC Motor Driver, DC Motor Driver, Motor Driver, Brushless Motor Driver, Driver
Unidades de DC sin escobillas BD10-H5-AH (180W)
File Info : application/pdf, 2 Pages, 5.55MB
DocumentDocumentBD BD5/10 Quick Setup Guide Requirements To begin, make sure you have the following equipment: A compatible motor. A small screwdriver for tightening the connectors (included). An I/O cable and connectors (included). Step 1 Wire the drive to the DC power source. Note, the BD5/10 accepts DC power from 12-48V. (Do not apply power until all connections to the drive have been made.) External (Line) Fuse Criteria For all DC supply currents up to 9A (this includes peak values) use a 12A fast-blo fuse. For all currents above 9A (this includes peak values) use a 15 A fast-blo fuse. The internal fuse is not user-replaceable, if tripped, the unit must be returned for repair. See the BD5/10 Hardware Manual for more details. +DC -DC LINE FILTER FUSE To Earth Ground (OPTIONAL) Locate an optional line filter adjacent to the drive for full CE compliance Step 2 Connect the motor to the drive. BD5/10 matched motors ship with 12" terminated connectors that will plug directly into the drive. If your motor is located out of reach of the standard cables, you may use an Applied Motion Products extension cable. (Do not connect the motor to the load until initial testing has been completed.) Grounding Screw BRUSHLESS DC MOTOR BL105-H03-G 24VDC Ins.Class E 6.25A IP40 105W YY-MM-DD 0.225N·M No.xxxxxx 4500r/min MADE IN CHINA 920-0066C Step 3 Ensure that DIP switch 1 is ON and 2 is OFF (to use internal power supply for I/O). Note, it may be necessary to remove the external cover to access the internal DIP switches. It may also be possible to access these switches by carefully reaching through the slots with the small screw driver that is included. Speed and accel/decel settings are controlled by on-board potentiometers, adjustable using the included screwdriver. Apply power to the drive. TESTING: To start the motor spinning, connect STP (pin11, black/white) to GND (pin2) and adjust the SPD pot to the desired speed. To reverse direction, connect CW/CCW (yellow) to GND (pin2). 17 M2 15 M1 13 M0 11 STP 9 SPST 7 EN/RE 5 STMD 3 CW/CCW 1 5V 18 INCOM 16 AGND 14 AIN 12 5V 10 SPO- 8 SPO+ 6 FLT- 4 FLT+ 2 GND CN4 SPD ACC/DEC Step 4 Your drive is now wired for use. For further details on I/O and general operation please consult the BD5/10 Hardware Manual, available at http://www.applied-motion.com/support/manuals. 920-0066C