User Manual for DMBH models including: INBIRDIEIMU, 2A3CBINBIRDIEIMU, INBIRDIEIMU InBirdie, INBIRDIEIMU InBirdie
DMBH Co., Ltd. INBIRDIEIMU InBirdie IMU 2A3CBINBIRDIEIMU 2A3CBINBIRDIEIMU inbirdieimu
InBirdie IMU User Manual Components Main Body (a charging cable is an option) Features POWER Button: The power is turned on if pressed with the power supply off. If pressed again, the power is turned off. Charging Port: If the battery is low, please charge the device with the USB Type C cable. LED Light Red: Charging Blue: Bluetooth is on Red: In operation A sharp pin designed to be plugged into a hole in the back of the putter NOTICES - Do not disassemble the product randomly. Otherwise, warranty service will not be provided. - Turn off the power before cleaning. Keep the device dry. Do not use any chemicals or alcohol. - Avoid direct sunlight and places with chemicals around for storage. - Direct sunlight may result in malfunction. Ensure to use the device without such intensive sunlight around. InBirdie IMU User Manual How To Use 1. Assemble the InBirdie IMU securely, using the hole at the tip of the putter grip as shown in the figure. 2. Press the button on top again. Then, the power is turned on, lighting up the LED lamp. 3. Switch on the InBirdie TEMPO. InBirdie TEMPO InBirdie IMU User Manual How To Use 4. Open the InBirdie game app. 1) When a guide to InBirdie TEMPO connection is heard, connect the device. 2) After such connection, a guide to InBirdie IMU connection is given. Then, connect the InBirdie IMU. If successfully connected, the connection status is shown as follows: 5. Results Once putting is done normally, InBirdie IMU analysis results additionally appear on the InBirdie game app. FCC Compliance Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to correct the interference by one of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. FCC Caution Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be colocated or operating in conjunction with any other antenna or transmitter. FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Product appearance and specifications are subject to change without notice for quality and performance improvements. DMBH CO., LTD. (http://www.dmbh.co.kr), Customer Service Center: 032-203-8889Microsoft PowerPoint 2019