iCON Qcon EX G2 MIDI/Audio Control Surface Quick Start Guide

Introduction

This guide provides instructions for setting up and using the iCON Qcon EX G2 MIDI/Audio control surface. It covers unpacking, installation, and configuration for various Digital Audio Workstations (DAWs).

1. Unpacking

Ensure you have the following items in the package:

• Qcon EX G2 x 1pc
• USB 2.0 Cable x 1
• AC adapter x 1pc
• Quick Start Guide x 1

Note: The Qcon EX G2 is a USB MIDI Controller.

2. Setup and Installation

Power: Connect the AC adapter to the power input and turn on the device.

Connection: Connect the Qcon EX G2 to your computer using the provided USB cable.

Configuration:

The Qcon EX G2 supports multiple modes for different DAWs. The following diagram illustrates how to connect and configure the device for various popular DAWs:

Supported DAWs and Configurations:

• Mackie Control / HUI: Compatible with Cubase, Nuendo, Logic Pro, Pro Tools, Studio One, Reaper, FL Studio, Digital Performer, Samplitude, Bitwig, Reason, and Audition.
• Configuration Steps:

The document shows specific screenshots for configuring the Qcon EX G2 within each DAW. These typically involve selecting the correct MIDI input/output ports and control surface type (e.g., Mackie Control or HUI) within the DAW's preferences or settings.

Example Configuration (General):

1. Open your DAW's preferences or settings menu.
2. Navigate to the MIDI or Control Surface setup section.
3. Add a new control surface.
4. Select the appropriate protocol (Mackie Control or HUI).
5. Assign the correct MIDI input and output ports for the Qcon EX G2 (e.g., 'iCON Qcon EX1 G2 V1.05').
6. Ensure the device is enabled and configured correctly within the DAW.

Note on Overlays: The document also shows different colored PVC overlays for the control surface buttons, corresponding to different languages (English, French, German, Italian, Spanish).

3. Manual Mode

The Qcon EX G2 can be used in Manual Mode, allowing for custom mapping of controls. The setup for Manual Mode involves selecting the device and configuring its parameters within the DAW's MIDI settings.

System Requirements

The document implies compatibility with Windows and macOS operating systems, as shown in the DAW configuration screenshots.

Troubleshooting

If the control surface is not recognized, ensure the USB cable is securely connected and the correct drivers (if any are required) are installed. Verify the MIDI ports are correctly assigned within your DAW.