Note: The Owner/Operator must read carefully and understand all the information presented here before operation.
Thank you for using this Drum Pallerizer. For your safety and correct operation, please carefully read this instruction before using it.
NOTE: All of the information reported herein is based on data available at the moment of printing. The factory reserves the right to modify its own products at any moment without notice and incurring in any sanction. So it is suggested to always verify possible updates.
1. Specification
| Model | DJ365 |
|---|---|
| Capacity | 365kg / 800lbs |
| Acceptable Drum Style | 55 gallon, steel |
| Overall Size L×W×H | 1250*1100*1250 mm |
| Net Weight | 60kg |
| Wheel (poly) Dia*Width | Diameter 150*50 mm, Diameter 100*32mm |
2. Notice
2.1 Do not operate this pallerizer more than 70m/min speed when overloading.
2.2 Do not operate the pallerizer unless you are trained and authorized.
2.3 Please operate the pallerizer on the hard surface.
2.4 Please push the drum when operating the pallerizer.
3. Operation
- Clamp the pawl handle for putting the handle on the top position.
- Push the drum near the pallet, the big hook button up the drum while two small hooks button up the side of drum, then pull the handle until the lowest position.
- When release the drum, press the handle down, then clamp the pawl handle and lower the handle slowly to put the drum on the ground.
4. Exploded View & Part List
The Drum Pallerizer consists of a robust base equipped with swivel wheels for maneuverability, a central vertical column, and an articulated arm assembly designed to securely grip and lift drums. A handle mechanism controls the lifting and lowering operations. The exploded view illustrates the individual components that make up the unit.
| No. | Description | Qty | Remark |
|---|---|---|---|
| 1. | Split pin | 2 | Diameter 3.2*32 mm |
| 2. | Hook assembly | 1 | |
| 3. | Pipe core | 1 | |
| 4. | Handle assembly | 1 | |
| 5. | Left columniation | 1 | |
| 6. | Hex bolt | 2 | M12*80 |
| 7. | Flat washer | 4 | Diameter 12 mm |
| 8. | Hex nut | 2 | M12 |
| 9. | Pneumatic columniation | 1 | |
| 10. | Hex bolt | 4 | M10*70 |
| 11. | Flat washer | 8 | Diameter 10 mm |
| 12. | Hex nut | 4 | M10 |
| 13. | Wheel | 2 | Diameter 150 mm |
| 14. | Wheel shield | 2 | |
| 15. | Hex nut | 2 | M12 |
| 16. | Right columniation | 1 | |
| Pawl handle | 2 | (Note: Pawl handle is part of the handle assembly) | |
| 17. | Pedestal | 1 | |
| 18. | Swivel wheel | 2 | Diameter 100 mm |
| 19. | Hex bolt | 8 | M10*20 |
| 20. | Flat washer | 8 | Diameter 10 mm |
| 21. | Spring washer | 8 | Diameter 10 mm |
