UHF/VHF Wireless Microphone Instruction Manual
Read instructions before using.
Introduction
Thank you for purchasing our wireless microphone. This manual provides essential information for optimal product performance and efficiency. Please read it carefully before use.
Function Indication
1. Comprehensive Natural Ability
- Frequency: UHF 550-568MHz
- Frequency stability: ±30ppm
- Frequency response: 75-12KHz
- Dynamic range: >80dB
- T.H.D: ≤1%
- S/N rate: >80dB
- Operating temperature: 0°C-45°C
- Service areas: 15m (30m if no block)
2. Fix Receiver
- Voltage of electric source: AC220/50Hz or AC110/60Hz
- Power: 1W
- Sensitivity: 30dB/uV
- False rate: >70dB
- Vicinity rate: >70dB
- Audio output: >25mV
3. Transmitter
- Transmitter power: 8.5Mw
- Concocting mode: FM
Caution:
- 1. Machine should not place to dead corner in order to keep good signal condition.
- 2. Please don't throw the microphone when using in order to avoid serious damage.
- 3. The machine should avoid direct solarization and drench and keep away from electromagnetic wave.
- 4. Please don't disassemble by yourself because there is huge voltage to harm your body.
Simple Malfunction Handling
Appearance | Reason | Solution |
---|---|---|
1. Power indication light darken when turn on the receiver power switch | Receiver circuit is not connected | Connect the power |
2. No sound | Wireless microphone do not turn to "on" position | Turn to "on" position |
No connection of receiver's audio frequency | Connect the circuit | |
The volume of receiver or amplifier is too small | Turn aloud properly | |
3. Receiving distance is too near | Distance of wireless microphone and receiver is too far | Go back to the service areas |
Antenna of receiver is not pulled out | Pull out | |
Battery power insufficient | Replace the batteries | |
4. Sound worsen | Battery power insufficient | Replace batteries |
Pronounce too loud and mouth close too much | Leave mouth a little |
If still isn't normal after checking by yourself, Please contact dealers.
Main Features
- Using UHF 550-568 MHz frequency to avoid the interference.
- Using multilevel high frequency and middle frequency narrowband filter, so as to dispel any possible interference signals.
- Using special ALC circuit to avoid losing your own sound due to big volume.
- With the low consumption components, the life of the battery will be much longer.
- With the power indication circuit in the handhold microphone, so you will know when to replace the battery.
- All use quartz crystal oscillating circuits, so the frequency is very steady.
- With the decreasing back-out whistle function, it can decrease the whistle efficiently.
- The tonality is quite good with the excellent crystal and components.
Microphone Operation
- Turn to "OFF" position of the switch, open the battery box cover, install the batteries (DC 9V) correctly, then cover back.
- Turn to "ON" position of the switch when using, turn to "SIN BY" position if don't using temporarily so that noise could not go through.
- If the indicated light of the microphone darken, please replace the batteries.
- Please take out the batteries in case the batteries get bad and worsen for the microphone if don't use for a long time.
Operation of the Receiver
- Put the plug into socket, and please make sure whether the voltage suitable or not.
- Turn on the electrical switch and the power indicated light turn on.
- Pull out antenna A & B, make it vertically.
- Using the cable to connect "Audio out" sound outlet and your karaoke phone inlet.
- When turn on the microphone, the "RF" of receiver signal light will turn on.
- The volume of receiver could be adjusted by the sound controlling rolling button.
- Please pull off the plug if don't use for a long time.
Name of the Parts (Handheld Microphone)
- 1. Cartridge
- 2. Handhold
- 3. Condition of batteries and power indication
- 4. Power and switch of microphone
- 5. Battery box
- 6. Display
Fittings
- 1. Headset
- 2. Lavalier belt pack
FCC Compliance Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
The devices has been evaluated to meet general RF exposure requirement, the device can be used in portable exposure condition without restriction.
Technical Specifications
Ant. | Antenna Brand | Antenna Model Name | Antenna Type | Connector | Gain (dBi) | NOTE |
---|---|---|---|---|---|---|
1 | N/A | N/A | Wire antenna | N/A | 0 | Antenna |
ANT 1
Test mode | Channel | Frequency (MHz) | Cable loss (dB) | Peak Output Power (dBm) | Antenna Gain (dBi) | EIRP(dBm) | Limit (dBm) | Verdict |
---|---|---|---|---|---|---|---|---|
Channel | CH 01 | 553.20 | 1.0 | 7.70 | 0 | 7.70 | 16.99 | PASS |
CH 02 | 565.80 | 1.0 | 7.58 | 0 | 7.58 |