iWALK Link Me Watch DBL9000W User Guide
Welcome to the iWALK Link Me Watch user guide.
Product Overview
The iWALK Link Me Watch (Model: DBL9000W) is a portable charger designed to support charging up to three devices simultaneously. It features pass-through charging, allowing you to recharge the power bank while it is charging another device.
Key Features:
- Supports up to 3 devices for simultaneous charging.
- Pass-through charging capability.
- Recommended charger: 5V/2.0A or higher for optimal charging.
Product Specifications
Product Name: Link Me Watch
Model No.: DBL9000W
Rated Energy: 33.3Wh
Conversion Rate: 60%
Rated Capacity: 9000mAh
Input:
- USB-C Port: 5V-2A
- Lightning Port: 5V-1.5A
Output:
- Output 1 (USB-C Port): 5V-2A
- Output 2 (Lightning Port): 5V-2A
- Output 3 (Lightning Cable): 5V-2A
- Output 4 (Apple Watch Wireless Charging): 3W
Product Dimensions: 100mm x 50mm x 30mm
Product Weight: 401g
Safety Precautions
- To preserve battery lifespan, use and recharge at least once every 4 months.
- Use original or certified cables.
- Do not expose to liquids.
- Do not disassemble.
- Avoid dropping the product.
- Avoid using the product in extreme temperatures (too low or too high).
Warranty Information
Thank you for purchasing an iWALK product. The warranty period is 12 months from the date of purchase. Free service will be provided for quality issues within the warranty period, provided the warranty card has the distributor's official stamp and a valid serial number (S/N).
Paid Service Conditions:
- No valid or incompatible warranty card.
- No S/N or incompatible S/N.
- Malfunctions caused by artificial damage (e.g., external impact, water submersion).
- Misuse of the product or failure to follow manual instructions.
- Product disassembly or repair by unauthorized personnel.
- Damage caused by storage in hot or humid environments.
- Defects or malfunctions due to force majeure.
Please complete the warranty card for future service.
FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
FCC Radiation Exposure Statement: This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
Contact Information
Service: Service@iWALK.NET
EU Logistic Center: 31-88-9277/277
Head Office: 86-592-5030-771/780 (Mon-Fri 09:00-17:00)
China: 400-8855-698 (Mon-Fri 09:00-17:00)
Social Media:
Company: U2O GLOBAL CO.,LTD.
Addresses:
- Dubai Logistic Center: 201, Atrium centre, Bank Street, Bur Dubai, UAE.
- Head Office: U2O Building, Huanzhu Road 385, Jimei, Fujian, China
- U.S. Office: 206 Terminal Drive Plainview, NY 11803
- Korea Office: 4.19-ro 13-gil, Ganbuk-gu, Seoul, Korea
- EU Logistic Center: A. Hofmanweg 75-2031BH Haarlem, Netherland
Manufacturer: 厦门广开电子有限公司 U2O GLOBAL CO.,LTD.
Factory Address: U2O Building, Huanzhu Road 385, Jimei District, Xiamen City, Fujian Province, China, 361021
Certifications
CE FC ROHS
Made in China
PA1127
