Two Handle Lavatory CenterSet Faucets

What You May Need

For easy installation of your faucet, please read all instructions completely before beginning, and review all warnings, care, and maintenance information.

Cleaning and Care: This product's finish is durable, but can be damaged by harsh abrasives or polish. To clean, gently wipe with a damp cloth and blot dry with a soft towel.

This faucet complies with California water efficiency regulations, California Proposition 65, and the Federal Safe Drinking Water Act.

Maintenance

If faucet exhibits very low flow:

1. Remove and clean the aerator with your hand.
2. Shut off water supply valves.
3. Replace the valve assembly (4).
4. When reinstalling parts, ensure the bonnet nut (5) is tightened securely with a wrench.

If faucet leaks from under the handle:

1. Using a wrench, ensure the bonnet nut (5) is tight.
2. If the leak persists, shut off water supply valves and replace the valve assembly (4).
3. When reinstalling parts, ensure the bonnet nut (5) is tightened securely with a wrench.

If faucet leaks from the spout outlet:

1. Shut off water supply valves.
2. Replace the valve assembly (4).
3. When reinstalling parts, ensure the bonnet nut (5) is tightened securely with a wrench.
4. Install the valve assembly (4) correctly for proper handle rotation.

Installation Instructions

Notes Before Installing Valves:

Thoroughly clean the water pipes to avoid dirt and deposits.

Step 1: Provided with necessary models. Optional: Use silicone under the base if the deck is uneven.

Step 2: Attach the mounting nut to the hot and cold threaded mounting shanks and tighten the faucet to the basin.

Step 3: Attach supply lines by tools. Do not overtighten. Turn the water back on.

Step 4:

1. Remove the washer (2), black gasket (4), and nut (5) from the assembly.
2. Slide washer (2) up to the underside of the flange (3).
3. Insert flange (3) and washer (2) into the sink and secure with the black gasket (4), washer, and nut (5) from underneath the sink.
4. Place and check the spring-loaded stopper (1).
5. Connect the assembly to the drain.

Step 5: Repeat for the other hose connection, ensuring the hose with the hot label is connected to the hot supply valve and the other hose is connected to the cold supply valve.

Step 6: Flush System / Check for Leaks. Turn on hot and cold water supplies and flush water lines for one minute. Check all connections for leaks. Retighten if necessary, but do not overtighten.

To flush debris from the plumbing system:

1. Remove the aerator by hand.
2. Run hot and cold water for one minute.
3. Replace the aerator.

Faucet Dimensions and Specifications

Overall Height: 10 inches (250mm)

Spout Height: 8.7 inches (220mm)

Spout Reach: 4.8 inches (123mm)

Handle Clearance: Min. 1.2 inches (32mm) to backsplash

Hole Size: 2x 1" to 1.5" (25mm to 38mm)

Pre-drilled Hole Size: 1" (25mm)

Deck Thickness: 0.2" (6mm) Min. to 1.2" (30mm) Max.

Hole Diameter: Min. 1.6" (Ø41mm)

Operation

• Double levers style handles.
• Maximum handle rotation is 90° to full on.
• Rotate hot side counter-clockwise to open (clockwise to close).
• Rotate cold side clockwise to open (counter-clockwise to close).