Vekkia Jump Starter & Portable Power Source

Model: THOR 1000

This user manual provides instructions for the Vekkia THOR 1000 Jump Starter and Portable Power Source.

Getting Started

Charging the jump starter

1. To charge the product, connect the jump starter and the power source via the provided Micro USB cable.
2. While charging, the battery level indicator lights will flash. All 4 lights will be solid when fully charged.
3. Unplug the cable when charging is not required.

Note:

• Ensure the jump starter is fully charged before first use.
• Use the provided Micro USB cable for charging.
• A wall charger is not included.

Power bank

1. Connect the product to your electronic device (e.g., iPhone, other smartphones, or tablets).
2. Press the ON/OFF button to activate the power output.
3. Unplug the cable once your device is fully charged.

LED flashlight

Long press the ON/OFF button for 3 seconds to turn on the light. Short presses cycle through Solid, SOS, Flash, and Off modes.

Jump start your car

Note: This product is for 12V cars only.

Ensure 3 to 4 indicator lights are on (battery level above 50%) before jump starting.

Step 1: Connect the smart battery clamp

Insert the smart battery clamp plug completely into the jump starter. The green and red indicator lights on the clamp should flash alternately, indicating it's safe to proceed.

Step 2: Connect clamps to the car battery

Connect the red clamp to the positive (+) terminal of the car battery and the black clamp to the negative (-) terminal.

If the green and red indicator lights on the battery clamp are flashing alternately, proceed to the next step.

Step 3-a: Start your car

Attempt to start your car within 30 seconds of connecting the clamps.

If the car does not start, disconnect the clamps from the vehicle and jump starter. Wait at least 30 seconds before trying again.

If the car fails to start after two attempts, use the force start function (Step 3-b).

Step 3-b (optional): Force start function

Ensure clamps are connected to the correct polarity battery terminals. Press and hold the force start button for 3 seconds. When the smart clamp indicator light turns solid green, start the vehicle within 30 seconds.

[Force Start Button] is indicated in the diagram.

Step 4: Remove the clamps

Once the car starts, remove the battery clamps from the car battery and jump starter as soon as possible.

NOTE: When jump starting multiple cars, disconnect the clamps and jump starter between vehicles and repeat steps 1-4.

Trouble Shooting

If the red indicator light is on:

1. The battery clamp may be connected in reverse. Disconnect and reconnect.
2. Ensure maximum contact between clamps and battery terminals.
3. The car battery voltage may be higher than 17.5V.
4. If connected for over 30 seconds, disconnect immediately and follow steps 1-2 again.

How to read indicator light of the battery clamp?

NOTE: When the green light is on (in the start state), do not remove the clamp to short-circuit them or reverse the positive and negative poles of the clamp to the car battery.