Instruction Manual for City Lights models including: U.H.O. LED Flush Mount Ceiling Light, U.H.O., LED Flush Mount Ceiling Light, Mount Ceiling Light, Ceiling Light

U.H.O. LED Flush Mount Ceiling Light - Instruction Guide

Installation Guide

U.H.O. LED Flush Mount Ceiling Light — City Lights SF

• Google Docs
• Google Drive
• Download [pdf]
• Download Optimized



File Info : application/pdf, 1 Pages, 260.76KB

Document Document

INSTALLATION INSTRUCTIONS FOR P950-X-L Ceiling Flush mount fixture"or"wall mount
WARNI NG ! S HUT P O W E R O F F AT F U S E O R C I R C U I T BRE AKE R.
AV E RT IS S E ME NT ! COUP E R LE C OUR ANT AU N IV E AU DE S FUS IB L E S OU DO DIS JON CT E UR .

PREPARATION 1. Shut off power at the fuse box or circuit breaker box. If
necessary remove the old fixture and mounting hardware. 2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1) 3. Secure mounting back plate (B) to junction box (A) using
junction boxes screws (C) (Size: 8-32*1/2"L). The side of the mounting back plate marked "GND" must face out.
CONNECTING THE WIRES (FIG. 2) 4. At this point, connect the electrical wires as shown in Fig. 2,
making sure that all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect the fixtures ground wire to it. Otherwise, connect the fixture ground wire directly to the back plate (B) using the green screw (E) provided. After wires are connected, tuck them carefully inside the junction box.

FIG.1

Set A# A-021-153D
Back plate Green screw Mounting Screws(2)

White wire

F E

A Black wire
D
H B C G

FINISHING THE INSTALLATION (FIG.1) 5. Align the fixture's back plate (G) over the mounting back
plate (B) and secure with screws (H).

CAUTION /ATTENTION : When handling the fixture, do not apply pressure to the LEDs.
MIN 90°C SUPPLY CONDUCTORS
LES FILS D'ALUMENTATION 90°C MIN
Replacing LED module (Fig. 3) The LED module can be replaced by a qualified electrician without cutting of wire and without damage to any decorative element to which the fixture is attached. See installation steps for more details (Fig 3.) a. Shut of the power. b. Remove finial (M) and acrylic shade (L). c. Remove nipple (O) and (N) located inside the fixture
backplate (I) to disconnect the LED module. d. Remove screws (K), Carefully remove the LED module (J)
Reverse steps a-c for installing the new LED module. e. Note: The LED module should be provided by a specified
supplier. f. For better heat dissipation the LED module (J) should be
applied with thermal grease when re-lamping.

Fig.2
FIXTURE WIRES Black or Smooth
Fig 3

FIXTURE WIRES White or Ribbed HOUSE WIRES Black (Hot)
N

FIXTURE WIRES Bare Copper (Ground)

HOUSE WIRES White (Neutral)

HOUSE WIRES Green or Bare Copper(G round)

G H I
J K O
L

Brand : Lutron
M

IMPORTANT: Fixture should be installed by a qualified electrician to ensure proper wiring and installation. Dimmable with C-L (CFL & LED) type and Incandescent/Halogen type dimmers