Instruction Manual for STMicroelectronics models including: CAM-6GY-084VIS, CAM-6GY-084VIS Time of Flight Sensor, CAM-6GY-084VIS, Time of Flight Sensor, of Flight Sensor, Flight Sensor, Sensor
CAM-66GY - CAM-66GY promodules: evaluation camera modules for VD66GY image sensor - STMicroelectronics
File Info : application/pdf, 2 Pages, 122.54KB
DocumentDocumentCAM-6GY-084VIS
Schematic diagrams
Note: These schematic diagrams refer to the latest version. Note 2: There is a need to add external capacitors at the host side for VDDIO, VCORE, VANA pins. Please refer to
"Application Schematic" section of the data sheet for more details.
Figure 1. Circuit schematic
CPPOS AVDD AGND DGND DVDD SDA SCL RESET DOVDD
CPPOS CPNEG LDP2V4 AVDD
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31
CPNEG
115 114 113 112 111 110 109 108 107 106 105 104 103 102 101 100
99
VANA AGND VANA VCORE VCPPOS_IN AGND VCORE NC NC NC VANA VANA DGND AGND VCPNEG_OUT VCPNEG_IN AGND
U1 VD66GY
VCPPOS_OUT VANA AGND DGND
VCORE AGND DGND
VCORE VANA VANA AGND
VCORE NC
VANA NC
AGND VANA DGND VCORE DGND VANA AGND VANA AGND DGND DGND
SDA SCL VCORE XSHUTDOWN VDDIO
NC GPIO0 PORTST DGND GPIO1 GPIO2 DGND VCORE DGND VCORE DGND LDO2V4 VCORE DGND VDDIO GPIO3 VCORE DGND GPIO4
NC VCORE DGND DGND DGND VCORE
AGND GPIO5 GPIO6 GPIO7 VDDIO VANA LDO2V4 DGND VCORE DGND CLKIN VDDIO
32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68
GPIO0 GPIO1 GPIO2
LDP2V4 GPIO3 GPIO4
GPIO5
MCLK
DGND
DOVDD DVDD VDDAMP
AGND
C1
C2
0.47uf
1uf
C3 0.1uf
C4 0.1uf
C5
C6
C7
1uf
0.47uf
0.1uf
AVDD DGND DOVDD GPIO0 GPIO1 GPIO2 GPIO3 GPIO4 GPIO5
SCL SDA
J1
1 3 5 7 9 11 13 15 17 19 21 23 25 27 29
VANA GND
GND VCORE
VDDIXOSHUTDN
GPIO0 GND
GPIO1 DATA1P
GPIO2 DATA1N
GPIO3 GND
GPIO4 CLKP
GPIO5 CLKN
NC
GND
NC DATA2P
GND DATA2N
SCL
GND
SDA CLKIN
GND
GND
2 4 6 8 10 12 14 16 18 20 22 24 26 28 30
SHWX85
R1 AGND
0R
DGND
DVDD RESET
MDP1 MDN1
MCP MCN
MDP2 MDN2
MCLK
VANA VCORE AGND DGND NC NC AGND AGND VCORE DGND RCALIB VDDAMP LDO2V4 DGND DATA1P DATA1N VDDAMP VCORE CLKP DGND CLKN VDDAMP DATA2P DATA2N DGND DGND VCORE VDDAMP DGND DGND
98 97 96 95 94 93 92 91 90 89 88 87 86 85 84 83 82 81 80 79 78 77 76 75 74 73 72 71 70 69
MDP1 MDN1
MCP MCN MDP2 MDN2 VDDAMP
CAM-6GY-084VIS - Rev 1 - Jun 2024 For further information contact your local STMicroelectronics sales office.
www.st.com
CAM-6GY-084VIS
IMPORTANT NOTICE READ CAREFULLY STMicroelectronics NV and its subsidiaries ("ST") reserve the right to make changes, corrections, enhancements, modifications , and improvements to ST products and/or to this document at any time without notice. Purchasers should obtain the latest relevant information on ST products before placing orders. ST products are sold pursuant to ST's terms and conditions of sale in place at the time of order acknowledgment. Purchasers are solely responsible for the choice, selection, and use of ST products and ST assumes no liability for application assistance or the design of purchasers' products. No license, express or implied, to any intellectual property right is granted by ST herein. Resale of ST products with provisions different from the information set forth herein shall void any warranty granted by ST f or such product. ST and the ST logo are trademarks of ST. For additional information about ST trademarks, refer to www.st.com/trademarks. All other product or service names are the property of their respective owners. Information in this document supersedes and replaces information previously supplied in any prior versions of this document.
© 2024 STMicroelectronics All rights reserved
CAM-6GY-084VIS - Rev 1
Page 2 of 2