Disney Frozen II Talk & Glow Olaf & Elsa

About the Product

This document provides instructions for the Hasbro Disney Frozen II Talk & Glow Olaf & Elsa interactive toy set. The set features characters from Disney's Frozen II movie, allowing for interactive play and dialogue between Elsa and Olaf.

Important Safety Information

Ages: 3+

⚠️ CAUTION: Hair entanglement may result if a child's hair comes in contact with moving parts of the toy. Adult supervision is required.

Note: For optimal play, use the toy on a smooth, flat, hard surface.

Battery Installation

Required: 5 x 1.5V AAA Alkaline Batteries.

Tools needed: Phillips/cross head screwdriver (not included).

Instructions for Battery Installation:

1. Locate the battery compartment on the toy.
2. Use a Phillips/cross head screwdriver to open the battery compartment cover.
3. Insert 5 x 1.5V AAA alkaline batteries, ensuring correct polarity (+ and -) as indicated inside the compartment.
4. Replace the battery compartment cover and secure it with the screwdriver.

How to Play

Follow these steps to activate the Talk & Glow Olaf & Elsa features:

1. Step 1: Power On
   Move the power switch from the 'Off' position ([Off]) to the 'On' position ([On]).
2. Step 2: Wake Olaf
   Gently nudge Olaf to wake him up. For the interactive features to work, Elsa should be facing Olaf, and both dolls should be within approximately 3 feet (0.9 meters) of each other.
3. Step 3: Activate Olaf's Features
   Lift Elsa's right arm. This action will cause Olaf to move, talk, and glow.
4. Step 4: Activate Different Phrases
   Lower Elsa's arm and then raise it again. This will activate a different phrase from Olaf. He will also move and glow with the new interaction.
5. Step 5: Sleep Mode
   After approximately 1 minute of inactivity, the dolls will automatically enter sleep mode (?).

Important Battery Information

CAUTION:

1. Keep small batteries away from small children who might put them in their mouths. If swallowed, seek immediate medical attention. Contact a doctor or local poison control center.
2. To Avoid Battery Leakage:
   • Always follow instructions carefully. Use only the specified batteries and insert them correctly, matching polarity markings (+ and -).
   • Do not mix old and new batteries, or standard (carbon-zinc) with alkaline batteries.
   • Remove exhausted or dead batteries from the product promptly.
   • Remove batteries if the product will not be used for an extended period.
   • Do not short-circuit the supply terminals.
   • Rechargeable Batteries: Do not mix rechargeable batteries with other types. Always remove them from the product before recharging. Recharge rechargeable batteries only under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
3. If the product experiences or is affected by local electrical interference, move it away from other electrical equipment. Reset the toy by switching it off and on again, or by removing and re-inserting the batteries if necessary.

Regulatory Information

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Consult the dealer or an experienced radio/TV technician for help.

CAUTION: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

CAN ICES-3 (B)/NMB-3(B)

General Information

Retain this information for future reference. © Disney.

Hasbro and all related trademarks and logos are trademarks of Hasbro, Inc. © 2019 Hasbro, Pawtucket, RI 02861-1059 USA. All Rights Reserved.

Conservez cette information pour référence ultérieure. © 2019 Hasbro. Tous droits réservés.

HASBRO CANADA, LONGUEUIL, QC, CANADA J4G 1G2. US/CANADA TEL. 1-800-255-5516.