ITC Warranty & Return Policy
Installation Guide for ITC models including: PH01-XBK, PH02-XBK, PH02-XBK Rotating Phone Holder, Rotating Phone Holder, Phone Holder, Holder
File Info : application/pdf, 2 Pages, 376.48KB
DocumentDocumentRotating Phone Holder Part#: PH01-XBK or PH02-XBK PARTS / TOOLS NEEDED: INSTALLATION INSTRUCTIONS Phone Holder #6 Pan Head Mounting Screws (not provided) Power Drill & Hole Saw Marine Grade Splices (not provided) Safety/Installation Considerations · Disconnect power before installing, adding or changing any component. · To avoid a hazard to children, account for all parts and destroy all packing materials. · Electrical Specs: Input voltage: 10-30V DC| Input Current: Wireless: 1A | USB-A: 1.9A | USB-C: 2.4A Charging Capacity: Wireless Only: 10W | Wireless + USB-A: 10W + 12W | Wireless + USB-C: 10W + 18W · Positive (+) outputs require a fuse if the attached wire leads are not rated to handle the max current. · The charger has been designed to work with Qi compatible devices. · The charger has been designed to charge and operate within the receiving device's thermal parameters. Low or high temperatures might cause the receiving device to change their charging behavior to regulate its temperature and preserve battery life. Typical temperature ranges are 0ºC to 35ºC (32ºF to 95ºF). When exceeding these operating temperatures, the phone and/or the charging device may temporarily stop charging to protect from overheating. · The wireless charging module has been designed to be optimized with no case installed. If a thick phone case is added to the distance between the charger surface and the phone it may cause the device to not charge or to temporarily shut down to protect from over-heating. 1. Determine the installation location and mark the mounting holes. Pre-drill the mounting holes and drill a 1" hole for the wire access. Product Type Surface Mount Articulating Arm Wire Access Hole Size 1" ½" 3030 Corporate Grove Dr. Hudsonville, MI 49426 Phone: 616.396.1355 itc-us.com Surface Mount Articulating Arm For warranty information please visit www.itc-us.com/warranty-return-policy DOC #: 710-00210 · Rev B · 08/23/23 Page 1 of 2 2. Screw the holder in place using #6 pan head screws (not provided) making sure to follow the top orienta- tion noted on the back of the part. Surface Mount Articulating Arm 3. Wire the phone holder using the wiring diagram. Phone Holder Positive (+) Negative (-) Fuse Incoming 10V - 30V DC Power 4. Surface Mount Version: Snap the holder into the mounting plate making sure to line up the TOP text on the mounting plate and phone holder. The phone holder can be rotated 90° so it can be viewed in portrait or landscape orientation. TOP TOP 3030 Corporate Grove Dr. Hudsonville, MI 49426 Phone: 616.396.1355 itc-us.com For warranty information please visit www.itc-us.com/warranty-return-policy DOC #: 710-00210 · Rev B · 08/23/23 Page 2 of 2