User Guide for LTC Networking Limited models including: RGB Gaming Mouse, RGB, Gaming Mouse, Mouse

说明卡制作文件

User manual

LTC Networking Limited 2312MS1 2A5EQ-2312MS1 2A5EQ2312MS1 2312ms1

PDF preview unavailable. Download the PDF instead.

GetApplicationAttachment.html?id=7168487
Quick Guide

01 Key Map

01 Left Key

02 Right Key

03 Scroll

04 Forward

04

05
05 Backward

06 DPI Loop

07 Power Switch

08 Charging Base Light Switch

01

02

03

07 06
08

02 Connections

Wired Mode

2.4G Mode

BT Mode

Bluetooth other devices
Add Bluetooth or other device Bluetooth
On
Now discoverable as" GM-022 "
*Enter Paring Mode: Press Left/Middle/Right Key at the Same Time for6 Seconds.
03 Charging
Flash: Need to Charge Flash: Charging On: Charging Complete

FCC Warning
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.


Adobe Illustrator(R) 24.0 PDFsharp 1.50.5147 (www sharp.com)