Important Installation Tips
- Assemble bottom with long bars first, so panel can slide in from side. Ensure openings on the corner fittings are facing down. ⬇️
- On side panels with cable openings, position the opening toward the back top corner.
- When attaching the top with screen, ensure the double track (for doors) is facing forward. ➡️
Parts List
- 1. Frames (aluminum)
- 2. Panels (5)
- 3. Door (2)
- 4. Mesh (screen built-in)
- 5. Support Bars (2)
- 6. Corner Fittings (8)
- 7. Cable Pass Through Port (2)
Note: The 48x24x12 and 36x18x18 enclosures will have a roll of double-sided tape in place of part 1E.
Assembly Steps
STEP 1 - Assemble bottom
a. Take out 4 corners (#6), 4 frames (1C, 2x1D, 1F), & 1 4x2 panel (2A).
b. Connect 3 aluminum frames to each end of 2 corner fittings.
c. Slide the bottom panel into the channels of the assembled frame. ➡️
d. Attach the other frame and corner fittings to secure the bottom panel. ✔️
STEP 2 - Assemble sides
a. Attach 2 back frames on the back left & right corner fittings.
b. Insert the acrylic panel into the bottom channel.
c. Connect the assembled frames to the bottom channels, and then slide the 3 side panels into the bottom channels. ➡️
When assembling the 48x24x12 and 36x18x18 enclosures, skip Step 2C. Instead, your last step will be to attach the acrylic panel using double-sided tape.
STEP 3 - Assemble top
a. The screen is already assembled. Screw in the support bars with U-shape clamp.
Ensure double channels on the pre-assembled screen top face forward. ➡️
Attach support bars under the screen with screws. ✔️
Connect with the assembled parts. ?
STEP 4 - Assemble door
a. Peel off the protective film on the acrylic doors, and then attach the door handles using screws M4*6mm.
Peel off the protective film, install the door handles onto the doors. ✔️
b. Insert the top edge of the left door into the back-top door rail, then align with the back bottom door rail and drop into place. Repeat vice versa for the other door.
Insert the door inside the door rail, one in front and the other on the back. ▶️
STEP 5 - Assemble Cable pass through port
a. Take apart the cable pass through port into two pieces. Open the acrylic door and install it on the side panel of the enclosure.
Position facing outwards ➡️ and inwards ⬅️.
The cable pass through port can switch location depending on position. ⚙️